Sony GV-D300 Operating Instructions - Page 70

English Trouble check If you run into any problem using the VCR, use the following table to troubleshoot the problem. Should the difficulty persist, disconnect the power source and contact your Sony dealer or local authorized Sony service facility. VCR Power Symptom Cause and/or corrective actions The power is not on. • The AC adaptor/charger is not connected to a wall outlet. m Connect the AC adaptor/charger to a wall outlet. (p. 8) • The battery pack is not installed. m Install the battery pack. (p. 17) • The battery is dead. m Use a charged battery pack. (p. 17) The battery pack is quickly discharged. • The ambient temperature is too low. (p. 64) • The battery pack has not been charged fully. m Charge the battery pack again. (p. 17) • The battery pack is completely dead, and cannot be recharged. m Use another battery pack. (p. 16) Operation Symptom Cause and/or corrective actions The tape does not move when a tape transport button is pressed. • The POWER switch is set to OFF. m Set it to ON. (p. 10) • The tape has run out. m Rewind the tape or use a new one. (p. 10) The tape does not start. • The tape is stuck to the drum. m Eject the cassette. (p. 9) • The tape has run out. m Rewind the tape or use a new one. (p. 10) • The tab on the cassette is out (red). m Use a new tape or slide the tab. (p. 9) The cassette cannot be removed from the holder. • The AC adaptor/charger is not connected to a wall outlet. m Connect the AC adaptor/charger to a wall outlet. (p. 8) • The battery is dead. m Use a charged battery pack or the AC adaptor/charger. (p. 8, 17) { and 6 indicators flash and no function • Moisture condensation has occurred. except for cassette ejection works. m Remove the cassette and leave the VCR for at least 1 hour. (p. 65) "CLOCK SET" appears when the VCR is • Reset the date and time. (p. 61) turned on. 70