Sony HCD-DX250 Operating Instructions (Main Stereo System) - Page 18
Installing the speakers on the wall, The screws should protrude 5 to 7 mm 7/32 to 9/32 inch.
View all Sony HCD-DX250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, see page 76. If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this happens, check the speaker connection again. Note • Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords are reversed, the sound will lack bass and may be distorted. Installing the speakers on the wall 1 Prepare screws (not supplied) that are suitable for the hole on the back of each speaker. See the illustrations below. 25 mm (1 inch) 4 mm (5/32 inch) 4.6 mm (3/16 inch) 10 mm (13/32 inch) Hole on the back of the speaker 2 Fasten the screws to the wall. The screws should protrude 5 to 7 mm (7/32 to 9/32 inch). 5 to 7 mm (7/32 to 9/32 inch) 3 Hang the speakers on the screws. 4.6 mm (3/16 inch) 10 mm (13/32 inch) Hole on the back of the speaker 18US