Sony HCD-ZX66I Operating Instructions - Page 34
Additional Information, Troubleshooting - repair
View all Sony HCD-ZX66I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Additional Information Troubleshooting Should you encounter a problem with your system, do the following: 1 Make sure the power cord and speaker cords are connected correctly and firmly. 2 Find your problem in the troubleshooting checklist below and take the indicated corrective action. If the problem persists after doing all of the above, consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. When the "/1 indicator flashes Immediately unplug the power cord and check the following items. • Are the + and - speaker cords short- circuited? • Are you using the supplied speakers? • Is anything blocking the ventilation holes on the rear of the unit? After checking the above items and fixing any problems, plug in the power cord again and turn on the system. If the "/1 indicator still flashes, or if the cause of the problem can not be found even after checking all the above items, consult your nearest Sony dealer. General The display starts flashing as soon as you plug in the power cord even though you have not turned on the system. • The demonstration mode started. Press "/1 (page 13). The clock or timer setting is canceled. • The power cord is disconnected or a power failure occurred. Redo "Setting the clock" (page 16). If you have set the timer, redo "Using the timer" (page 32). "- -:- -" appears in the display. • The clock is not set. Set the clock (page 16). • A power failure has occurred. Set the clock (page 16) and timer settings (page 32) again. There is no sound. • Turn VOLUME + clockwise (or press VOLUME + repeatedly on the remote). • The headphones are connected to the PHONES jack. • Check the speaker connections (page 11). • Check the speaker system setting (page 25). There is no microphone sound. • Turn VOLUME +/- clockwise (or press VOLUME + repeatedly on the remote) or turn MIC LEVEL clockwise to adjust the microphone volume. • Make sure the microphone is connected to the MIC 1 or MIC 2 jack correctly. 34US