Sony HDR-CX580V Operating Guide - Page 81
HDR-PJ260/PJ260V/PJ580/PJ580V, PJ580/PJ580V/PJ600/PJ600V
![]() |
View all Sony HDR-CX580V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
How to prevent moisture condensation When you bring your camcorder from a cold place into a warm place, put your camcorder in a plastic bag and seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the surrounding temperature (after about 1 hour). When the camcorder is connected to a computer or accessories Do not try to format the recording media of the camcorder using a computer. If you do so, your camcorder may not operate correctly. When connecting the camcorder to another device with communication cables, be sure to insert the connector plug in the correct way. Pushing the plug forcibly into the terminal will damage the terminal and may result in a malfunction of the camcorder When the camcorder is connected to other devices through a USB connection and the power of the camcorder is turned on, do not close the LCD panel. The image data that has been recorded may be lost. connect an accessory, press down and push it to the end, and then tighten the screw. To remove an accessory, loosen the screw, and then press down and pull out the accessory. When you are recording movies with an external flash (sold separately) connected to the accessory shoe, turn off the power of the external flash to prevent charging noise being recorded. You cannot use an external flash (sold separately) and the built-in flash at the same time. When an external microphone (sold separately) is connected, it takes precedence over the builtin microphone. On Wireless Remote Commander (HDR-PJ260/PJ260V/PJ580/PJ580V/ PJ600/PJ600V) Remove the insulation sheet before using the Wireless Remote Commander. Insulation sheet Others/Index Notes on optional accessories We recommend using genuine Sony accessories. Genuine Sony accessories may not be available in some countries/regions. Active Interface Shoe (HDR-CX580V/ PJ580/PJ580V/PJ600/PJ600V) The Active Interface Shoe supplies power to accessories such as a video light, a flash, or a microphone (sold separately). The accessory can be turned on or off as you open or close the LCD screen of your camcorder. Refer to the operating instructions supplied with your accessory for details. The Active Interface Shoe has a safety device for fixing the installed accessory securely. To Point the Wireless Remote Commander towards the remote sensor to operate your camcorder (p. 13). When no commands have been sent from the Wireless Remote Commander within a certain period, the light blue frame disappears. When you press any of or ENTER again, the frame appears at the position where it was displayed last. You cannot select some buttons on the LCD screen using To change the battery of the Wireless Remote Commander While pressing on the tab, inset your fingernail into the slit to pull out the battery case. Place a new battery with the + side facing up. Insert the battery case back into the Wireless Remote Commander until it clicks. US 81
![](/manual_guide/products/sony-hdrcx580v-operating-guide-b563c96/81.png)