Sony HT-DDW750 Operating Instructions - Page 15
Normal Speaker and Micro, Satellite Speaker, Specifying the speaker, parameters
View all Sony HT-DDW750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Hooking Up and Setting Up the Speaker System When placing surround speakers behind you (wide room) B A A 45° Sub woofer C C 90° 20° Note Do not place the center speaker further away from the listening position than the front speakers. Normal Speaker and Micro Satellite Speaker For HT-DDW750, the speaker size and the sub woofer selection has been preset to "MICRO SP." (Micro Satellite Speaker) according to the supplied speaker system. When you select "MICRO SP.", the speaker size and sub woofer selection has been configurated as follows: Speaker FRONT CENTER SURROUND SUB WOOFER Settings SMALL SMALL SMALL YES You cannot change the configuration if you select "MICRO SP.". If you change the speaker system, select "NORM. SP.". You can adjust the speaker size and sub woofer selection when you select "NORM. SP." (page 17). To select "NORM. SP.", turn off the power, then turn on again while pressing MAIN MENU. (To reset to "MICRO SP.", do the same procedure.) Tip The setting for Micro Satellite Speaker (MICRO SP.) has been programmed to optimize the sound balance. If you use Sony's Micro Satellite Speakers, select "MICRO SP.". Caution When you use Micro Satellite Speakers and the speaker size is set to "LARGE", you may not obtain the correct soundstage. The speaker may also be damaged at high volume position. Specifying the speaker parameters 1 Press MAIN MENU repeatedly to select " SET UP ". 2 Press MENU or MENU to select the parameter you want to adjust. 3 Press MENU + or MENU - to select the setting you want. The setting is entered automatically. 4 Repeat steps 2 and 3 until you have set all of the parameters that follow. Initial settings Parameter L R DIST. X.X m (XX ft.)* C DIST. X.X m (XX ft.)* SL SR DIST. X.X m (XX ft.)* SL SR PL. XXXX Initial setting 3.0 m (10 ft.)* 3.0 m (10 ft.)* 3.0 m (10 ft.)* LOW * The default unit for models of area code U, CA is "ft.". The default unit for models of other area code is "m". continued 15GB