Sony HT-DDW830 Operating Instructions - Page 48

Specifications Speaker Section SS-MSP1 Front, center and rear speakers Speaker system Full range, magnetically shielded Speaker units 8 cm cone type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity (Maximum input power) 100 watts Sensitivity level 85 dB (1 W, 1m) Frequency range 160 Hz - 20, 000 Hz Dimensions (w/h/d) Approx. 92 x 133 x 115mm including front grille Mass Approx. 1 kg SA-WMSP1 subwoofer AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 8 ohm loads, from 28 - 200 Hz; rated 50 watts, minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output (USA model only). System Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer: 20 cm cone type Enclosure type Acoustically Loaded Bass Reflex Continuous RMS power output (8 ohms, 20 - 250 Hz 50 W Reproduction frequency range 28 Hz - 200 Hz High frequency cut-off frequency 150 Hz General Power requirements Models of area code U, CA 120 V AC, 60 Hz Models of area code SP 230 V AC, 50/60 Hz Models of area code AU 240 V AC, 50/60 Hz Power consumptions 50 W Dimensions (w/h/d) Approx. 270 x 325 x 385 mm including front panel Mass Approx. 10 kg Supplied accessories See page 4. For details on the area code of the component you are using, see page 3. Design and specifications are subject to change without notice. The specification measured is under: • 230 V AC, 50 Hz condition. (models of area code SP) • 240 V AC, 50 Hz condition. (models of area code AU) Input LINE IN (input pin jack) Additional Information 48