Sony KDL-40S3000 Instructions (SU-WL500 Wall-Mount Bracket) - Page 10
Step 5: Installing the TV on the wall, with the TV to the TV. - base
UPC - 027242710276
View all Sony KDL-40S3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Step 5: Installing the TV on the wall 1 2 If you intend to install a TV that is not specified on page 2, be sure to refer to its operating instructions, or the supplied leaflet. WARNING Be sure to complete the installation before connecting the AC power cord to the wall outlet. If you allow the AC power cord to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. Be careful not to stumble over the AC power cord or the TV, as you may hurt yourself. Mounting Hook 1 Connect the AC power cord and the connecting cable(s) supplied with the TV to the TV. Connect the AC power cord and the connecting cable(s) to the connectors on the rear of the TV. For details on connecting the AC power cord and the connecting cable(s), refer to the instruction manual of the TV. Notes • You cannot connect the cables to the TV after installing it on the Base Bracket. • Subcontract the cable routing in the wall to a licensed contractor. Base Bracket 3 Firmly secure the TV and the Base Bracket using the two supplied screws (+BVST4 × 12). 2 Install the TV onto the Base Bracket. 1 Referring to the Screw and Hook locations diagram/table on page 13, determine the holes of the Base Bracket for latching the upper hooks of the Mounting Hook. 2 Hold the TV securely with both hands, and gently align it on the wall. WARNING Be sure that two or more persons hold the TV when carrying it. Screw (+BVST4 × 12) Note When using an electric screwdriver, set the torque setting to approximately 1.5 N·m {15 kgf·cm}. WARNING Be sure to tighten both left and right securing screws firmly. If you fail to do so, the TV may fall when it is pushed upward and cause injury. 10 (GB)