Sony KDL-46EX710 Additional Information for Using Sony® Wall-Mount Bra - Page 9

6 Adjust the angle of the Mounting Hook using the hexagon wrench supplied with the Wall-Mount Bracket. When installing the TV parallel to the wall (0 degrees), adjustment of the Mounting Hook angle (procedures  and  below) is not necessary. Make sure that each arm base X is screwed in securely.  Remove the two screws from the arm base X of the Mounting Hook. Choose the holes corresponding to the desired angle (5, 10, 15 or 20 degrees).  Adjust the angles of the top Y and bottom Z arm to fit the corresponding hole, and firmly secure each arm using the two screws removed in the previous procedure . Hexagon wrench ✍ • Be sure to adjust the right and left arms to the same angle. • Make sure that the two arm bases are screwed in securely. CAUTION Be careful not to pinch your fingers when adjusting the angle of the Mounting Hook. 7 Remove the screws from the back of the TV. Do not remove any other screws from the TV. KDL-32EX6*, KDL‑32EX7*, KDL-40EX6*, KDL‑40EX7*, KDL‑40HX800 only * In the actual model names, the "" indicates numbers and/or characters specific to each model. 8 Lift the TV off the stand. Make sure that you carry out this task with at least two or three people. Do not attempt to lift the TV by yourself. For holding and carrying the TV, refer to your TV's instructions. Additional Information for Using Sony Wall-Mount Bracket (SU-WL500) −  −