Sony KDL-48R550C Operating Instructions - Page 9

Recommended Measures to Secure the TV Consider the following measures when securing your TV to a Stand (not supplied). 1 Secure the Stand for the TV. Make sure the Stand can adequately support the weight of the TV. Use two angle braces (not supplied) to secure the Stand. For each angle brace use the appropriate hardware to:  Attach one side of the angle brace to the wall stud.  Attach the other side to the Stand. Angle braces (not supplied) The length of the M6 machine screw differs depending on the rope or chain diameter. Please refer to below illustration. 8 - 12 mm US Screw M6 TV Rope or chain 3 Anchor the TV to the wall by using bolts, wall anchor and chain (or rope). Wall-mount holes Stand 2 Secure the TV to the Stand. Use the optional hardware listed as follows (not supplied):  M6 machine screws (screwed into the TV's rear cover).  A screw or similar (attach it to the Stand).  Rope or chain (strong enough to support the weight of the TV). Make sure that there is no excess slack in the rope or chain. TV's rear cover M6 machine screw (not supplied) Screw (not supplied) Rope or chain (not supplied) M6 eye bolts (not supplied) Rope or chain (not supplied) Wall-anchor (not supplied) Please see below illustration for M6 eye bolt length. 8 - 12 mm M6 eye bolt TV's rear cover Note • Your TV is shipped with screws attached to the rear of the TV depending on the TV model. (They are fastened in the screw holes for wall mounting.) Be sure to remove the upper two screws prior to anchoring the TV to a wall. • Securing the TV to the Stand without securing the TV and the Stand to the wall provides minimum protection against the TV toppling over. For further protection, be sure to follow the three measures recommended. 9US