Sony KV-2511CR Primary User Manual - Page 17
Antenna/cable, Connection
View all Sony KV-2511CR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
ANTENNA/CABLE CONNECTION If you cannot obtain satisfactory reception with an indoor antenna, using an outdoor antenna may be necessary. Cable TV reception Is only possible by connecting a cable supplied by your local cable operator. Prepare the antenna or cable end using the appropriate connector, and connect the antenna or cable to the antenna terminal of theN. (See A, B or C below.) Combination VHF/UHF antenna,* VHF antenna, UHF antenna or CMV cable Select the proper connector according to the cable type. When the cable is a 75ohm When the cable is a 300-ohm coaxial type (round) ribbon type lead-in (flat) B When both VHF and UHF antennas are connected Prepare the VHF antenna end using the appropriate connector as Illustrated in A. Attach an optional EAC-66 UN mixer to the TV antenna terminal, and connect the cables to the UN mixer. Rear of TV VHF VHF/UHF UHF Use an optional F-type connector. Rear of TV VHF/UHF Attach the supplied antenna connector. 15 mm (Oa In.) ' Fasten with a screwdriver L(a ;Antenna connector *most combination antennas are equipped with a signal splitter. Take off the splitter and attach the proper connector. Note to CATV system installer In the U.S.A: This reminder is provided to call the CAN system installer's attention to Article 820-22 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. The supplied antenna connector will be used also as a UN mixer. When connecting both 75-ohm VHF and 300-ohm UHF antennas, or 300-ohm UHF antenna only; EAC-66 When the cable is connected to the TV with the UN mixer, snow and noise may appear In the pictures of the cable TV channels over 37 (VV-i-1). C Cable with a special converter (decoder) Pay cable TV systems use scrambled or encoded signals and require special converters (decoders)* in addition to the normal cable connection. Connect the converter (decoder) with a 75-ohm coaxial cable (optional). AUX TO CONVERTER VHF/UHF Should be horizontal To turn the slot, use a coin or a similar object. Input Output Pay TV Cable Special converter (decoder) * The special converter (decoder) will be supplied by the cable company. 17