Sony LBT-D107 Operating Instructions - Page 18
Troubleshooting, Guide
View all Sony LBT-D107 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Troubleshooting Guide Before going through the check list below, first refer back to the connections and operating procedures. Should any problem persist after you have made these checks, consult your nearest General No power Symptom No sound Reversed left and right sound Severe hum and noise Cause AC power cord is not connected securely. The VOLUME control is not turned up. Wrong connection Wrong connection Loose connections The unit is located near TVNCR. Remedy Connect the AC power cord securely. Turn up the volume. Connect the speakers correctly. Connect the speakers correctly. Make connections securely. Move TVNCR away from the unit. Tuner Symptom The"TUNED"orSTEREO"indication blinks. Cause Antenna is not aimed in the right direction. Received signals are weak. Severe hum or noise Antenna is not aimed in the right direction. Received signals are weak. Remedy Adjust the location and direction of the antenna. Connect to an external antenna if the indication still blinks even after adjusting the antenna. Adjust the location and direction of the antenna. Connect to an external antenna if hum or noise still interferes with reception. Cassette Deck Symptom You can not record on a tape. You cannot dub tapes. Unbalanced tone in higher frequencies Unclear recording or playback Cause The tab has been removed from the cassette. The tab of the cassette in deck B has been removed. The DOLBY NR switch is not in the correct position. Dirty head Excessive wow or flutter, or sound dropout Incomplete erasure. Dirty capstans and pinch rollers Magnetized erasing head Remedy Cover it with a piece of adhesive tape. Cover it with a piece of adhesive tape. Set the DOLBY NR switch to ON or OFF as was set for recording. Clean and demagnetize the recording/ playback heads. Clean the capstan and pinch roller. Demagnetize the erasing head. 18