Sony MEX-XB120BT Operating Instructions - Page 8
Getting Started, Detaching the Front Panel, Resetting the Unit, Setting the Clock - bluetooth pairing
View all Sony MEX-XB120BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Getting Started Detaching the Front Panel You can detach the front panel of this unit to prevent theft. 1 Press and hold OFF until the unit turns off, press the front panel release button , then pull the panel towards you to remove. Resetting the Unit Before operating the unit for the first time, or after replacing the car battery or changing connections, you must reset the unit. Press RESET on the inner panel with a ballpoint pen, etc., after detaching the front panel. Note Resetting the unit will erase the clock setting and some stored contents. Caution alarm If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used. Serial numbers Make sure the serial numbers on the bottom of the unit and the back of the front panel are matched correctly. Otherwise you cannot make BLUETOOTH pairing, connection and disconnection by NFC. Attaching the front panel Setting the Clock 1 Press MENU, rotate the control dial to select [GENERAL], then press it. 2 Rotate the control dial to select [SET CLOCK-ADJ], then press it. The hour indication flashes. 3 Rotate the control dial to set the hour and minute. To move the digital indication, press / (SEEK -/+). 4 After setting the minute, press MENU. The setup is complete and the clock starts. To display the clock Press DSPL. Checking the Battery Voltage You can check the current battery voltage. (Not available while the source is off and the clock is displayed.) 1 Press DSPL repeatedly until the battery voltage display appears. 8GB