Sony MZ-N1 Operating Instructions - Page 57
Symptom, Cause/Solution, A Premastered MD is inserted - drivers
View all Sony MZ-N1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Symptom Cause/Solution The recorder does not work or works poorly. • The disc is record-protected ("SAVED" appears). , Slide the tab (page 52). • Recording level is too small to record (when recording manually). , Pause the recorder and adjust the recording level. • A Premastered MD is inserted ("PbONLY" appears) when recording. , Insert a recordable MD • You tried to turn group mode on while setting the program. , Turn group mode on before setting the program. The recorder overwrites existing materials when record. • The record starting-position setting ("R-Posi") is set to "FrHere". , Set "R-Posi" setting to "Fr End". The recorder does not work while connected to the computer. • The computer does not recognize the recorder. , Verify that the recorder is correctly connected. , Install the driver correctly into your computer. , Install the OpenMG software into your computer first, and then connect the recorder. "No SIG" appears in the display when recording from a portable CD player. • There is no digital signal from the portable CD player. , When recording digitally from a portable CD player, use the AC power adaptor and disable the anti-skip function (such as ESP) on the CD player (page 20). There is no recording • The AC power adaptor was unplugged or a power outage on the MD after a occurred during recording. recording operation. The lid does not open. • The power sources have been disconnected during recording or editing, or the battery have been exhausted. , Set the power sources again, or replace the exhausted battery with new ones. • The lid is not firmly closed. , Close the lid until it clicks. Then pull the OPEN switch to open the lid. No sound comes through the headphones/ earphones. • The headphones/earphones plug is not firmly connected. , Plug in the plug of the headphones/earphones firmly to i. • Volume is too low. , Adjust the volume by pressing VOL +/-. • The plug is dirty. , Clean the plug. Volume cannot be turned up. • AVLS is on. , Set AVLS to "OFF" (page 48). An MD is not played • Playback mode is changed. normally. , Change to the normal play. 57-GB