Sony MZ-N10 Notes: using batteries -and- charging - Page 1

MZ-N10 Notes on using the recorder together with a dry battery • It is recommended that you use the recorder only after attaching the dry battery case and inserting a new dry battery into the case. • If the recorder has not been used for a few days after the battery became exhausted and "LOW BATT" appeared in the display, the recorder may not operate even after you insert a new dry battery or attach the dry battery case with a battery in it. If this happens, charge the built-in rechargeable battery and then try using the recorder again. Notes on charging • When the recorder has not been used for a long time, the charge lamp will not light up immediately after you place the recorder on the USB cradle. If this happens, leave the recorder on the cradle for a few minutes, and then take the recorder off and reset it on the cradle. Also make sure that the BUILT-IN BATTERY switch at the rear of the recorder is set to ON. • It is recommended that you charge the built-in rechargeable battery immediately after "LOW BATT" appears in the display. • Set the BUILT-IN BATTERY switch at the rear of the recorder to OFF if the recorder will not be used for a long time. For details, refer to the operating instructions supplied with the recorder. Sony Corporation  2003 Printed in Japan 0-429-743-11(1)