Sony NSZ-GS7 Quick Setup Guide - Page 1

Quick Setup Guide In the Box © 2012 Sony Corporation Printed in China 4-421-775-11(1) GB Network Media Player AC power cord Remote control (mains lead) (1) (Remote) (1) R6 (size AA) To insert batteries into the batteries (2) remote control Quick Setup Guide (1) Getting Started (1) Reference Guide and other documents Network Media Player NSZ-GS7 IR (infrared) Blaster cable (1) What's this? The IR Blaster enables you to control connected devices with your remote. Please see "To control connected devices using the remote" shown below for more information. Connection 1 step Connect to your TV Follow : A to connect to your TV directly. : B to connect to your TV via AV Receiver : C if your connection differs from the diagrams below. A Direct to TV B To TV via AV Receiver HDMI cable (not supplied) AV Receiver HDMI cable (not supplied) TV TV C Other connection See Help Guide for other connection patterns. From your PC http://www.sony.net/helpguide/r/networkplayer/ From your smartphone (optional) Set Top Box / Personal Video Recorder HDMI cable (not supplied) (optional) Set Top Box / Personal Video Recorder HDMI cable (not supplied) 2 step Prepare for Network connection 3 step Connect to the power source (mains) AC power cord (mains lead)  Connect to the power source (mains)  Change the TV input Wireless LAN router*1*2 Broadband router*2 LAN cable (not supplied) Switch the input selector on the TV so that the signal from the player appears on your TV screen. Then, a screen that shows how to setup your remote appears. Note This will only appear the first time you setup your player. *1 When using wireless connection, you need to set the Network Setup in the Initial Setup Wizard (on step 4). *2 You can find MAC address in the Initial Setup Wizard (step 4) as needed. Select "Explain step" on "Connect to the Internet" screen. 4 step Start the Initial Setup Wizard Follow the directions for the Initial Setup displayed on screen. - The screen may stay dark for several seconds after the Sony logo appears, then the Initial Setup screen appears. - When the Initial Setup screen (on which a picture of a player and a hand holding a remote is displayed) appears, press and hold (Enter) to pair your remote with the player. - Complete the Network setup process, otherwise the Initial Setup Wizard cannot be closed. - It takes about 15 minutes to complete the Initial Setup. To control connected devices using the remote This player is equipped with a built-in IR Blaster that accepts remote commands and sends them to various connected devices to control them with your remote. This function works when the player is turned on. When you set the player close to a connected device (as illustrated on the right), you can control the device using the remote, including operations such as adjusting the volume of the TV or an AV Receiver. However, if you place the player in a location where IR signals cannot reach, you cannot control connected devices with the built-in IR Blaster. In this case, connect the supplied IR Blaster as follows:  Connect the IR Blaster cable to the player.  Place the IR Blaster so that the infrared transmitter points to the IR receiver (sensor) on the device you want to control, as illustrated on the right. IR Blaster * * Location of the IR receiver may vary depending on the product you are using.