Sony NWZ-W262 Notes on Water Resistant Specifications (Please read before usin - Page 1
Sony NWZ-W262 Manual
View all Sony NWZ-W262 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
NWZ-W262/W263 Notes on Water Resistant Specifications (Please read before using your "WALKMAN") Scenarios*1 • You can use your "WALKMAN" while jogging or walking in the rain. • You can continue to use your "WALKMAN" after perspiring. • After using your "WALKMAN," you can wash it with fresh water at room temperature or gently running tap water.*2 *1 Do not use your "WALKMAN" in places when inability to hear surrounding sound would be dangerous. In all of the situations above, use your "WALKMAN" with the USB jack cover closed securely. *2 Follow the instructions described in "Cleaning after use" on the reverse side. ©2011 Sony Corporation Printed in Malaysia 4-287-516-11(1) Water resistant performance of this "WALKMAN" The water resistant specifications*1 of this "WALKMAN" are equivalent to IEC60529 "Degrees of protection against ingress of water (IP Code)" IPX5*2 that specifies as "Degrees of protection against ingress of water," Please note, however, that your "WALKMAN" is not completely water-tight. *1 The water resistant specifications are met only when the USB jack cover of your "WALKMAN" is closed securely. Also note that the headphone sections are not water-tight. *2 IPX5 (Degrees of protection against jets of water): Your "WALKMAN" will maintain its operability even when exposed to direct streams of water from any direction in a situation where approximately 12.5 l/min of water is supplied for more than 3 minutes from a distance of about 3 m using a nozzle with an inner diameter of 6.3 mm. However, this does not apply with the headphone sections. Headphone section (not water-tight) Liquids that the water resistant performance specifications apply to Applicable Not applicable : fresh water, tap water, perspiration : liquids other than those above (examples: soapy water, detergent water, water with bath agents, shampoo, hot spring water, pool water, seawater, etc.) The water resistant performance of your "WALKMAN" is based on our measurements under the conditions described above. Note that malfunctions as a result of water immersion caused by misuse by the customer are not covered by the warranty. Notes on charging the battery The USB cable supplied with your "WALKMAN" is not water resistant. Before charging the battery, make sure your "WALKMAN" is not wet. Be careful not to splash water or allow moisture to form on the USB cable. Never use the USB cable with wet hands or with your "WALKMAN" wet. Doing so may cause electric shock. When you charge the battery, be careful of the following. • Make sure that the location where you are using the USB cable is not wet. • Before charging the battery, make sure your "WALKMAN" is not wet. If there is moisture on your "WALKMAN," wipe it off completely, and leave your "WALKMAN" at room temperature to dry it until no moisture remains on your "WALKMAN" before you start charging. • Charge the battery in an ambient temperature of 5 °C (41 °F) to 35 °C (95 °F). If you charge the battery in an ambient temperature out of this range, charging may stop to protect the internal circuitry of your "WALKMAN." USB jack cover