Sony PC120BT Network Function Operating Instructions - Page 15

Preparation - Preparation - Registering a Bluetooth device This section describes making a registration of a Bluetooth device. Here we describe the procedure for registering the Sony Modem Adaptor with Bluetooth Function. Once the registration is completed, the camcorder can connect to the Bluetooth device without reregistering the device. Up to three Bluetooth devices can be registered. Also, refer to the operating instructions supplied with the Bluetooth device. For more information about Bluetooth devices compatible with the camcorder, access the following URL: • http://www.sony.ca/service •http://www.sony-europe.com/imaging, then click "support" • http://www.sony-asia.com.sg/helpdesk Only for the DCR-IP7BT/PC120BT The Sony BTA-NW1 Modem Adaptor with Bluetooth Function is supplied with the DCR-IP7BT/PC120BT. This unit has already been registered to your DCR-IP7BT/ PC120BT. Notes •When using the Sony BTA-NW1 Modem Adaptor with Bluetooth Function, install it in a location that has no obstacles between the camcorder and the device. The distance between the devices must be within 10 m (33 feet). •The connection may be interrupted depending on the conditions in which the communication is taking place. When using the Modem Adaptor with Bluetooth Function 1 Preparing the Modem Adaptor with Bluetooth Function Set the Modem Adaptor with Bluetooth Function to connection standby (BONDING). For details, refer to the operating instructions supplied with the Modem Adaptor with Bluetooth Function. 15-GB