Sony PEGA-KB20 Operating Instructions - Page 1
Sony PEGA-KB20 - Mini Keyboard Manual
UPC - 027242605527
View all Sony PEGA-KB20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
4-663-796-13 (1) Mini Keyboard Operating Instructions Mode d'emploi PEGA-KB20 Sony Corporation © 2002 Printed in Japan English WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Owner's Record The model and lot numbers are located on the bottom of your mini keyboard. Record the lot number in the space provided below. Refer to the model and lot numbers when you call your Sony dealer regarding this product. Model No. PEGA-KB20 Lot No. For the customers in the USA This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including any interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. If you have a question about this product, call the Sony Customer Information Center at keep on next line 1-877-760-7669; or write to the Sony Customer Information Center at 12451 Gateway Boulevard, Fort Myers, FL 33913. The number below is for FCC-related matters only. Declaration of Conformity Trade Name: SONY Model No.: PEGA-KB20 Responsible Party: Sony Electronics Inc. Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone No.: 201-930-6972 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. For the customers in Canada This Class B digital apparatus complies with Canadian ICES-003. For the customers in the European Countries This device complies with the following European Directives: 89/336/EEC, 92/31/EEC (EMC Directives) 93/68/EEC (CE Marking Directive) Printed on 100% recycled paper using VOC (Volatile Organic Compound)free vegetable oil based ink. This product complies with EN 55022 Class B and EN 55024 for use in the following areas: residential, commercial and light industrial. • CLIÉ and Jog Dial are trademarks of Sony Corporation. • All other trademarks are trademarks of their respective owners. Before use This Mini Keyboard is adaptable only for Sony CLIÉ Handheld. It is easy to carry, and handy when you use it with Sony CLIÉ Handheld while traveling. Installing the software Before using the Keyboard, install a Keyboard driver from the supplied installation CD-ROM on your CLIÉ Handheld. For installation, you need a Windows PC on which the Palm Desktop software that is suitable for your CLIÉ Handheld has been installed. Connect the PC to your CLIÉ Handheld, and make sure that HotSync works on both the PC and CLIÉ Handheld. 1 Insert the supplied installation CD-ROM into the CD- ROM drive of your PC. The initial installation screen appears. 2 Click [Install software for Mini Keyboard]. The installer submenu appears. 3 Install the software, following the instructions shown on the screen. If you have registered more than one user, select a user name from the user list. 4 Click [Done]. 5 Press the HotSync button on the cradle. HotSync starts and the software is transmitted from your Windows PC to CLIÉ Handheld. Note Re-installing the driver for the Mini Keyboard in your CLIÉ Please perform re-installation, once you delete the driver already installed in your CLIÉ. If the driver is not deleted beforehand, malfunction may occur. If a fault occurs, please perform a soft reset, according to the operating instructions for your CLIÉ. Attaching the Keyboard to your CLIÉ Handheld 1 Attach the Keyboard to the CLIÉ Handheld, as if to put it onto the CLIÉ Handheld, as shown. Press down firmly. The graffiti area should be covered by the Keyboard. 2 Hook up the connector of the Keyboard to the interface connector of the CLIÉ Handheld. Interface connector 3 Attach the drop-prevention strap to the Keyboard and CLIÉ Handheld. For detaching, press the retaining parts from both sides. Removing the Keyboard 1 Remove the Keyboard while pressing the center portion on the connector of the Keyboard, as shown. 2 Remove the Keyboard from the CLIÉ Handheld. 3 Remove the drop-prevention strap by pressing the retaining parts from both sides. z Be sure to attach the drop-prevention strap when you use the Keyboard. The CLIÉ Handheld and Keyboard are easily detachable. To prevent injury, or damage to them, be sure to attach the strap. Extending the cord Detaching the cover on the back of the Keyboard lengthens the cord by about 30 mm. 1 Detach the cover on the back of the Keyboard and extend the cord as shown. Detach the cover. Extend the cord. 2 Put the cover back in its place. Using the Keyboard After attaching the Keyboard to your CLIÉ Handheld, you can use the Keyboard by the following procedure. 1 Press the POWER button on the CLIÉ Handheld to turn the power on. 2 Tap the [Mini Key] icon on the Home screen. The Keyboard-setting screen appears. 3 Tap and select the check box for [Enable Keyboard] in the Keyboard-setting screen. The Keyboard is ready to use now. Setting the click sound for the Keyboard You can set the sound that is heard when you click the keys. 1 Tap [Mini Key]. The Keyboard-setting screen appears. 2 Tap and select the check box for [Enable Key Clicks] in the Keyboard-setting screen. The click sound is heard when you press the keys. To turn off the click sound, deselect the check box for [Click sound] in the Keyboard-setting screen. Carrying your CLIÉ Handheld with the Keyboard attached Set the HOLD switch on the Keyboard to ON. The Keyboard does not accept any key operation and prevents the CLIÉ Handheld from operating without your knowledge. When you use the Keyboard again, set the HOLD switch to OFF. Shortcut keys Keys to press Function Fn + Blue letter key Selects the blue letter code. Shift + Alphabetic keys; - with CapsLock off Enters capital letters. - with CapsLock on Enters lower-case letters. Shift + b Selects preceding text. Shift + B Selects continuing text. Shift + Ctrl + b Selects all preceding text. Shift + Ctrl + B Selects all continuing text. Shift + Ctrl + v Rotates the Jog Dial navigator upward while holding it down. Shift + Ctrl + V Rotates the Jog Dial navigator downward while holding it down. Shift + Ctrl + Tab Jumps back to the previous field. Ctrl + C Copies the selected text. Ctrl + X Cuts the selected text. Ctrl + V Pastes the selected text. Ctrl + D Deletes the selected text. Ctrl + L Turns on/off the backlight. Ctrl + H Goes to the Home (Launcher) screen. Ctrl + M Goes to the Menu screen. Ctrl + F Does a search. Ctrl + v Rotates the Jog Dial navigator upward. Ctrl + V Rotates the Jog Dial navigator downward. Ctrl + Presses the Jog Dial Navigator. Ctrl + (Hold it down.) Holds down the Jog Dial Navigator. Ctrl + BS Presses the Back button. Ctrl + BS (Hold it down.) Holds down the Back button. Ctrl + Tab Jumps to the next field. Application key settings Keys to press Function Home Goes to the Home (Launcher) screen. Menu Goes to the Menu screen. Calc *Opens the onscreen Calculator. Search Goes to the Search screen. Date Book *Opens the Date Book. Address Book *Opens the Address Book. To Do List *Opens the To Do List. Memo Pad *Opens the Memo Pad. * You can open other applications you have assigned to each button by changing Preferences. Keys corresponding to Latin characters Keys Top BS Tab T t R r SP ; , . A B C D E F G H I J K L M N O P Q R S T U V W X Y Z +Alt BS - £ º ÿ SP CapsLock+Alt BS SP See reverse side.