Sony PX40 Operating Instructions - Page 38
Maintenance, Replacing the Lamp
UPC - 027242602793
View all Sony PX40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
B Maintenance Maintenance 2 Open the lamp cover by loosening a screw with the Phillips screwdriver. Replacing the Lamp When the lamp has burnt out or dims, or "Please replace the LAMP." appears on the screen, replace the lamp with a new one. Use LMP-P260 Projector Lamp as the replacement lamp. The lamp life varies depending on conditions of use. When replacing the lamp after using the projector Turn off the projector, then unplug the power cord. Wait for at least an hour for the lamp to cool. Caution The lamp becomes a high temperature after turning off the projector with the I / 1 key. If you touch the lamp, you may scald your finger. When you replace the lamp, wait for at least an hour for the lamp to cool. Notes • If the lamp breaks, consult with qualified Sony personnel. • Pull out the lamp by holding the handle. If you touch the lamp, you may be burned or injured. • When removing the lamp, make sure it remains horizontal, then pull straight up. Do not tilt the lamp. If you pull out the lamp while tilted and if the lamp is broken, the pieces may scatter, causing injury. 1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside. Note Be sure that the projector is stable after turning it over. Note For safety sake, do not loosen any other screws. 3 Loosen the three screws on the lamp unit with the Phillips screwdriver. Pull out the lamp unit by the handle. Handle Note • The screws have washers. Do not remove the screws, just loosen them. GB 38 Maintenance