Sony RCP-1500 Operating Instructions - Page 1

4-541-888-02(1) ࣭ྔ 1.8 kg mmʣ 2- 5 102 85 67 Remote Control Panel Operation Guide 310 332.2 355 ͢ɻ RCP-1500 RCP-1501 RCP-1530 102 67 85 © 2014 Sony Corporation Printed in Belgium Ԍ͕ग़ͨΒ PoE 概要 RCP-1500 CD-ROM Adobe Reader ·͢ɻ Adobe Reader͸ɺAdobe 1 CD-ROM index.html 2 C D - R O M 仕様 DC 10.5 V ʙ 30 V 4 W 5 ˆʙ 40 ˆ ೖग़ྗ REMOTE CCU/CNU AUX EXT I/O RJ-45‫ܕ‬8ϐϯʢ1ʣ 8 1ʣ 8 1ʣ 9ϐϯɺԜʢ1ʣ ෇ଐ඼ 1 CD-ROMʣʢ1ʣ ผച඼ ֎෦I/OίωΫλʔ JAE DE-9PF-N 1-568-182-11 CCA-5-3 3 mʣ CCA-5-10 10 mʣ CCA-5-30 30 mʣ A VCCI-A English Before operating the unit, please read this manual thoroughly and retain it for future reference. WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. For the customers in the U.S.A. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. All interface cables used to connect peripherals must be shielded in order to comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC Rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For the customers in Canada This Class A digital apparatus complies with Canadian ICES-003. For the customers in Europe This product with the CE marking complies with the EMC Directive issued by the Commission of the European Community. Compliance with this directive implies conformity to the following European standards: ˎˎEN55103-1: Electromagnetic Interference(Emission) ˎˎEN55103-2: Electromagnetic Susceptibility(Immunity) This product is intended for use in the following Electromagnetic Environment: E4 (controlled EMC environment, ex. TV studio). For the customers in Europe, Australia and New Zealand WARNING This is a Class A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures. For the customers in Europe This product has been manufactured by or on behalf of Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. Inquiries related to product compliance based on European Union legislation shall be addressed to the authorized representative, Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or guarantee matters, please refer to the addresses provided in the separate service or guarantee documents. This apparatus shall not be used in the residential area. For the State of California, USA only Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate For the customers in Taiwan only About the network connector CAUTION ˎˎWhen you connect the LAN cable of the unit to peripheral device, use a shielded-type cable to prevent malfunction due to radiation noise. ˎˎFor safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. ˎˎThis unit is to be connected only to PoE networks without routing to the outside plant.