Sony RM-PP505L Primary User Manual - Page 13

Advanced Remote Operations x X N n M. > m Learning the commands of your components By using the Learning function, it is possible for this remote to perform learned commands. Setting remote control codes that are not stored in the remote When a remote control code is not one of the presets stored in the remote, it is possible for the remote to learn the code using the Learning function. 1 Press SLEEP while pressing down USE MODE. The indicator lights. 2 Press the function button for the component you want to learn functions for. For example, if you are going to learn an operation for a CD player, press CD. 3 Press the button you want to use for the Learning function. The indicator turns off while a valid button is pressed, then blinks slowly. 4 Point the remote control code receiver section of the remote toward the receiver/transmitter on the remote control to be learned. 5-15 cm 5 Press the appropriate button on the remote control to be learned to send the remote button code. Lightly pressing the button once should be sufficient. If learning is completed successfully, the indicator slowly lights twice and the remote automatically exits the learning mode. If the memory of the remote is already full, the indicator flashes 8 times in quick succession and the remote automatically exits the learning mode. When learning is not completed successfully, the indicator lights 4 times in quick succession and the procedure returns to step 5. Notes • You can program up to 80 buttons for the Learning function. In some cases, you may not be able to program even if you have not programmed 80 buttons. • In steps 2 and 3, the indicator turns off while a valid button is pressed. • In step 3, if several buttons that can be used for learning are pressed, only the last pressed button is valid. • In step 5, if a button that can be used for learning is pressed, the new button is selected and the learning procedure returns to the beginning of step 5. • You can use TV/VIDEO only for the MONITOR function. To cancel learning Press USE MODE during any step. The remote automatically exits the learning mode. To clear the learned codes Start over from step 1. After step 3, press SLEEP for more than 2 seconds. The indicator lights twice slowly and the learned code is cleared. When a learned code is cleared, if the button was previously programmed for another function, the programmed code for that button can be used. continued 13