Sony SCD-C2000ESB Operating Instructions - Page 24
Troubleshooting, After you have attempted the, prescribed corrective actions
View all Sony SCD-C2000ESB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Troubleshooting If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There is no sound. • Check that the player is connected securely. • Make sure you operate the amplifier correctly. • When you use the headphones, adjust the volume with LEVEL. There is no sound from the DIGITAL (CD) OUT connectors. • The audio signals of the Super Audio CD cannot be output from the DIGITAL (CD) OUT connectors. The disc does not play. • There is no disc inside the player. • Place the disc on the disc tray with the label side up. • The disc is placed at an angle. Reload the disc. • Clean the disc (see page 23). • Moisture has condensed inside the player. Remove the disc and leave the player turned on for about an hour. • There is an incompatible disc on the tray (see page 4). The remote does not function. • Remove any obstacles in the path of the remote and the player. • Point the remote at the remote sensor on the player. • If the batteries in the remote are weak, replace with new ones. • Be sure that the command mode of the remote (position of the CD1/2 switch) (page 28) matches the command mode of the player (page 9). There is no sound from the SUB WOOFER jack. • Select a playback mode in which the sub woofer signal is output from the SUB WOOFER jack. The mode indication is displayed with "+ SW" (page 17) when such a mode is selected. • When you play a track that does not contain the LFE signal, the signal outputs from the SUB WOOFER jack only when you select "5- SMALL+SW" or "F-LARGE+SW" for Multichannel mode (page 17). A disc cannot be ejected and "LOCKED" appears in the front panel display. • Contact your Sony dealer or local authorized Sony service facility. "REMOVE" is displayed in the front panel display. • Remove the disc in front of you and turn off the player once, and then turn it on again. After you have attempted the prescribed corrective actions If the player still does not operate properly, or if other problems not described above occur, turn off the player, unplug it from the power outlet for a few minutes, then reinsert the plug into the power outlet. 24US