Sony SEL20F28 Operating Instructions - Page 1
Sony SEL20F28 Manual
View all Sony SEL20F28 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
4-457-821-01(1) Interchangeable Lens Objectif interchangeable Operating Instructions Mode d'emploi Manual de instrucciones SEL20F28 E 20mm F2.8 E-mount ©2013 Sony Corporation Printed in Thailand 2 1 3 4 -1 (1) (2) -2 E A ͳΕ·ͤΜɻ 1 Β̍ʙ 2 1 2 3 4 1 1ʣɺʢ2ʣͷ2 2 3 ɾDMF ओͳ༷ 35mm 1 ʢmmʣ ը֯*1 2ʢmʣ mmʣ E20mm F2.8 (SEL20F28) 30 6-6 70° 0.2 0.12 f/16 49 ʢɿmm gʣ E20mm F2.8 (SEL20F28) 62.6 × 20.4 69 *1 ͜͜Ͱͷ35mm APS-CαΠ *2 ಉࠝ Ϩϯζʢ1 1 1 1ʣɺ This instruction manual explains how to use lenses. Precautions common to all lenses such as notes on use are found in the separate "Precautions before using". Be sure to read both documents before using your lens. This lens is designed for Sony α camera system E-mount cameras. You cannot use it on A-mount cameras. Notes on Use ˎˎWhen carrying a camera with the lens attached, always firmly hold both the camera and the lens. Precautions on using a flash ˎˎWhen using a flash, shoot at least 1m (3.3 feet) away from your subject. With certain combinations of lens and flash, the lens may partially block the light of the flash, resulting in a shadow at the bottom of the picture. Vignetting ˎˎWhen using the lens, the corners of the screen become darker than the center. To reduce this phenomena (called vignetting), close the aperture by 1 to 2 stops. Identifying the Parts 1 Lens hood index 2 Focusing ring 3 Lens contacts* 4 Mounting index * Do not touch the lens contacts. Attaching and Detaching the Lens To attach the lens (See illustration -.) 1 Remove the rear and front lens caps and the camera body cap. ˎˎYou can attach/detach the front lens cap in two ways, (1) and (2). 2 Align the white index on the lens barrel with the white index on the camera (mounting index), then insert the lens into the camera mount and rotate it clockwise until it locks. ˎˎDo not press the lens release button on the camera when mounting the lens. ˎˎDo not mount the lens at an angle. To remove the lens (See illustration -.) While holding down the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens. Attaching the Lens Hood (supplied) It is recommended that you use a lens hood to reduce flare and ensure maximum image quality. Align the red line on the lens hood with the red line on the lens (hood index), then insert the lens hood into the lens mount and rotate it clockwise until the red point on the lens hood is aligned with the red line on the lens (hood index) and the lens hood clicks into place. ˎˎWhen using a built-in camera flash or a flash supplied with the camera, remove the lens hood to avoid blocking the flash light. ˎˎYou can attach a filter or front lens cap to the lens hood as well. ˎˎDepending on the filter you use, you can attach the lens hood after attaching the filter to the lens. Focusing There are three ways to focus. ˎˎAuto focus The camera focuses automatically. ˎˎDMF (Direct manual focus) After the camera focuses in auto focus, you can make a fine adjustment manually. ˎˎManual focus You focus manually. For details on mode settings, refer to the instruction manual supplied with the camera. Specifications Product name (Model name) Equivalent 35mm-format focal length*1 (mm) Lens groups-elements Angle of view*1 Minimum focus*2 (m (feet)) Maximum magnification (X) Minimum f-stop Filter diameter (mm) Dimensions (maximum diameter × height) (approx., mm (in.)) Mass (approx., g (oz)) E20mm F2.8 (SEL20F28) 30 6-6 70° 0.2 (0.66) 0.12 f/16 49 62.6 × 20.4 (2 1/2 × 13/16) 69 (2.4) *1 The values shown above for equivalent 35mm-format focal length and angle of view are for Interchangeable Lens Cameras equipped with an APS-C sized image sensor. *2 Minimum focus is the shortest distance from the image sensor to the subject. ˎˎDepending on the lens mechanism, the focal length may change with any change in shooting distance. The focal lengths given above assume the lens is focused at infinity. Included items Lens (1), Front lens cap (1), Rear lens cap (1), Lens hood* (1), Set of printed documentation * It is attached to the lens on shipment. Design and specifications are subject to change without notice. is a trademark of Sony Corporation. Cette notice explique comment se servir des objectifs. Les précautions communes à tous les objectifs, par exemple les remarques sur l'emploi, se trouvent sur la feuille « Précautions avant toute utilisation ». Veuillez lire les deux documents avant d'utiliser votre objectif. Votre objectif est conçu pour les appareils photo à monture E de type Sony α. Il ne peut pas être utilisé pour les appareils photo à monture A. Remarques sur l'emploi ˎˎLorsque vous portez un appareil photo avec l'objectif dessus, tenez toujours fermement l'appareil photo et l'objectif. Précautions concernant l'emploi d'un flash ˎˎSi vous utilisez un flash, prenez la photo à au moins 1 m (3,3 pieds) du sujet. Associé à certains types de flash, l'objectif peut bloquer partiellement la lumière du flash et produire un ombre au bas de l'image. Vignetage ˎˎLorsque l'objectif est utilisé, les coins de l'écran deviennent plus sombres que le centre. Pour réduire ce phénomène (appelé vignetage), fermez l'ouverture de 1 ou 2 crans. Identification des éléments 1 Repère de parasoleil 2 Bague de mise au point 3 Contacts d'objectif* 4 Repère de montage * Ne touchez pas les contacts d'objectif. Pose et dépose de l'objectif Pour poser l'objectif (Voir l'illustration -.) 1 Déposez les capuchons d'objectif avant et arrière et le capuchon de l'appareil photo. ˎˎVous pouvez poser et déposer les capuchons d'objectif avant de deux façons, (1) et (2). 2 Alignez le repère blanc du barillet d'objectif sur le repère blanc de l'appareil photo (repère de montage), puis posez l'objectif sur la monture de l'appareil photo et tournez-le dans le sens horaire de sorte qu'il s'encliquette. ˎˎN'appuyez pas sur le bouton de libération de l'objectif sur l'appareil photo lorsque vous posez l'objectif. ˎˎNe posez pas l'objectif de biais. Pour déposer l'objectif (Voir l'illustration -.) Tout en appuyant sur le bouton de libération de l'objectif sur l'appareil photo, tournez l'objectif dans le sens antihoraire jusqu'à l'arrêt, puis déposez l'objectif. Fixation du parasoleil (fourni) Il est conseillé d'utiliser un parasoleil pour réduire la lumière parasite et obtenir la meilleure image possible. Alignez la ligne rouge du parasoleil sur la ligne rouge de l'objectif (repère de parasoleil), puis insérez le parasoleil sur la monture d'objectif et tournez-le dans le sens horaire jusqu'à ce que le point rouge du parasoleil s'aligne sur la ligne rouge de l'objectif (repère de parasoleil) et que le parasoleil s'encliquette. ˎˎLorsque vous utilisez le flash intégré d'un appareil photo ou le flash fourni avec un appareil photo, retirez le parasoleil pour éviter de bloquer la lumière du flash. ˎˎVous pouvez aussi poser un filtre ou un capuchon d'objectif avant sur le parasoleil. ˎˎAvec certains filtres, vous pouvez fixer le parasoleil après avoir mis le filtre sur l'objectif. (Suite à la page arrière)