Sony SEL35F14Z Operating Instructions - Page 1
Sony SEL35F14Z Manual
View all Sony SEL35F14Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
4-545-833-02(1) Interchangeable Lens Objectif interchangeable Operating Instructions Mode d'emploi Manual de instrucciones Distagon T FE 35mm F1.4 ZA E-mount ©2015 Sony Corporation SEL35F14Z Printed in Thailand 2 345 1 6 7 8 -1 (1) (2) -2 a E A Distagon T FE 35mm F1.4 ZAιχʔͱ ZEISS E ZEISS ZEISS 35mm 35mm APS-C http://www.sony.co.jp/DSLR/support/ 1̼Ҏ্ 2 1 2 3 ߜΓࢦඪ 4 ߜΓϦϯά 5 ߜΓ 6 7 8 1 1ʣɺʢ2ʣͷ2 2 2 3 ɾDMF A F1.4 ʙ F16 Χϝϥ͕MϞʔυ·ͨA F OFF a OFF ON ओͳ༷ Distagon T F1.4 ZA (SEL35F14Z) mmʣ 35 1ʢmmʣ 52.5 8-12 ը֯1*2 44° ը֯2*2 63° 3 mʣ 0.3 0.18 ࠷খߜΓ F16 mmʣ 72 ʢɿmmʣ 78.5×112.0 gʣ 630 ͳ͠ FE 35mm *1 APS-C 35mm *2 ը֯135mm 2APS-C *3 ಉࠝ Ϩϯζʢ1 1 1 1 1 This instruction manual explains how to use lenses. Precautions common to all lenses such as notes on use are found in the separate "Precautions before using". Be sure to read both documents before using your lens. This lens is designed for Sony α camera system E-mount cameras. You cannot use it on A-mount cameras. The Distagon T FE 35mm F1.4 ZA was developed jointly by ZEISS and Sony Corporation and designed for Sony E-mount cameras. This lens is produced under the strict standards and quality assurance system of ZEISS. The Distagon T FE 35mm F1.4 ZA is compatible with the range of a 35mm format image sensor. A camera equipped with a 35mm format image sensor can be set to shoot at APS-C size. For details on how to set your camera, refer to its instruction manual. For further information on compatibility, visit the web site of Sony in your area, or consult your dealer of Sony or local authorized service facility of Sony. Notes on Use ˎˎWhen carrying a camera with the lens attached, always firmly hold both the camera and the lens. ˎˎThis lens is not water-proof, although designed with dust-proofness and splash-proofness in mind. If using in the rain etc., keep water drops away from the lens. Precautions on using a flash ˎˎWhen using a flash, always remove the lens hood and shoot at least 1 m (3.3 feet) away from your subject. With certain combinations of lens and flash, the lens may partially block the light of the flash, resulting in a shadow at the bottom of the picture. Vignetting ˎˎWhen using the lens, the corners of the screen become darker than the center. To reduce this phenomena (called vignetting), close the aperture by 1 to 2 stops. Identifying the Parts 1 Lens hood index 2 Focusing ring 3 Aperture index 4 Aperture ring 5 Aperture scale 6 Lens contacts* 7 Aperture click switch 8 Mounting index * Do not touch the lens contacts. Attaching and Detaching the Lens To attach the lens (See illustration -.) 1 Remove the rear and front lens caps and the camera body cap. ˎˎYou can attach/detach the front lens cap in two ways, (1) and (2). When you attach/detach the lens cap with the lens hood attached, use method (2). 2 Align the white index on the lens barrel with the white index on the camera (mounting index), then insert the lens into the camera mount and rotate it clockwise until it locks. ˎˎDo not press the lens release button on the camera when mounting the lens. ˎˎDo not mount the lens at an angle. To remove the lens (See illustration -.) While holding down the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens. Attaching the Lens Hood It is recommended that you use a lens hood to reduce flare and ensure maximum image quality. Align the red line on the lens hood with the red dot on the lens (lens hood index), then insert the lens hood into the lens mount and rotate it clockwise until it clicks into place and the red dot on the lens hood is aligned with the red dot on the lens. ˎˎWhen using a built-in camera flash or a flash supplied with the camera, remove the lens hood to avoid blocking the flash light. ˎˎWhen storing, fit the lens hood onto the lens backwards. Focusing There are three ways to focus. ˎˎAuto focus The camera focuses automatically. ˎˎDMF (Direct manual focus) After the camera focuses in auto focus, you can make a fine adjustment manually. ˎˎManual focus You focus manually. For details on mode settings, refer to the instruction manual supplied with the camera. Adjusting the exposure When you align "A" on the aperture scale to the aperture index, the camera is set to auto iris mode and the exposure is set by the camera. And you can adjust the amount of light between f/1.4 and f/16 by rotating the aperture ring. Adjust the amount of light manually Rotate the aperture ring to the desired exposure (f-stop) when the camera is set to the M mode or A mode. Notes Set the aperture click switch to OFF when shooting movies. (See illustration -a) When the aperture click switch is set to OFF, the sound of the aperture ring is reduced. (For movie recording) If you change the aperture value while shooting a movie with the aperture click switch set to ON, the sound of the aperture ring will be recorded. Specifications Product name (Model name) Distagon T FE 35mm F1.4 ZA (SEL35F14Z) Focal length (mm) 35 35mm equivalent focal length*1 (mm) 52.5 Lens groups-elements 8-12 Angle of view 1*2 44° Angle of view 2*2 63° Minimum focus*3 (m (feet)) 0.3 (0.98) Maximum magnification (X) 0.18 Minimum aperture f/16 Filter diameter (mm) 72 Dimensions (maximum diameter × height) (approx., mm (in.)) 78.5 × 112.0 (3 1/8 × 4 1/2) Mass (approx., g (oz)) 630 (22.3) Shake compensation No function *1 This is the equivalent focal length in 35mm format when mounted on an Interchangeable Lens Digital Camera equipped with an APS-C sized image sensor. *2 Angle of view 1 is the value for 35mm cameras, and angle of view 2 is the value for Interchangeable Lens Digital Cameras equipped with an APS-C sized image sensor. *3 Minimum focus is the distance from the image sensor to the subject. ˎˎDepending on the lens mechanism, the focal length may change with any change in shooting distance. The focal lengths given above assume the lens is focused at infinity. Included items Lens (1), Front lens cap (1), Rear lens cap (1), Lens hood (1), Lens case (1), Set of printed documentation Design and specifications are subject to change without notice. is a trademark of Sony Corporation. Cette notice explique comment se servir des objectifs. Les précautions communes à tous les objectifs, par exemple les remarques sur l'emploi, se trouvent sur la feuille « Précautions avant toute utilisation ». Veuillez lire les deux documents avant d'utiliser votre objectif. Votre objectif est conçu pour les appareils photo à monture E de type Sony α. Il ne peut pas être utilisé pour les appareils photo à monture A. Le Distagon T FE 35mm F1.4 ZA qui a été développé en collaboration par ZEISS et Sony Corporation est destiné aux appareils photo à monture E de Sony. Cet objectif a été fabriqué selon les normes strictes et le système d'assurance qualité de ZEISS. Le Distagon T FE 35mm F1.4 ZA est compatible avec la plage d'un capteur d'image de format 35 mm. Un appareil photo équipé d'un capteur d'image de format 35 mm peut être réglé pour la prise de vue en APS-C. Pour les détails sur la manière de régler l'appareil photo, reportez-vous à son mode d'emploi. Pour plus d'informations sur la compatibilité, consultez le site de Sony de votre pays, ou adressezvous à un revendeur Sony ou à un service aprèsvente agréé Sony. Remarques sur l'emploi ˎˎLorsque vous portez un appareil photo avec l'objectif dessus, tenez toujours fermement l'appareil photo et l'objectif. ˎˎCet objectif n'est pas étanche à l'eau bien qu'il soit conçu pour résister à la poussière et aux éclaboussures. Si vous l'utilisez sous la pluie, etc. veillez à ce que de l'eau ne tombe pas dessus. Précautions concernant l'emploi d'un flash ˎˎLorsque vous utilisez un flash, retirez toujours le parasoleil et prenez vos photos à au moins 1 m (3,3 pieds) du sujet. Associé à certains types de flash, l'objectif peut bloquer partiellement la lumière du flash et produire un ombre au bas de l'image. Vignetage ˎˎLorsque l'objectif est utilisé, les coins de l'écran deviennent plus sombres que le centre. Pour réduire ce phénomène (appelé vignetage), fermez l'ouverture de 1 ou 2 crans. Identification des éléments 1 Repère de parasoleil 2 Bague de mise au point 3 Repère d'ouverture 4 Bague d'ouverture 5 Échelle d'ouverture 6 Contacts d'objectif * 7 Commutateur d'encliquetage de l'ouverture 8 Repère de montage * Ne touchez pas les contacts d'objectif. Pose et dépose de l'objectif Pour poser l'objectif (Voir l'illustration -.) 1 Déposez les capuchons d'objectif avant et arrière et le capuchon de l'appareil photo. ˎˎVous pouvez poser et déposer les capuchons d'objectif avant de deux façons, (1) et (2). Si vous posez/déposez le capuchon d'objectif avec le parasoleil, utilisez la méthode (2). 2 Alignez le repère blanc du barillet d'objectif sur le repère blanc de l'appareil photo (repère de montage), puis posez l'objectif sur la monture de l'appareil photo et tournez-le dans le sens horaire de sorte qu'il s'encliquette. ˎˎN'appuyez pas sur le bouton de libération de l'objectif sur l'appareil photo lorsque vous posez l'objectif. ˎˎNe posez pas l'objectif de biais. Pour déposer l'objectif (Voir l'illustration -.) Tout en appuyant sur le bouton de libération de l'objectif sur l'appareil photo, tournez l'objectif dans le sens antihoraire jusqu'à l'arrêt, puis déposez l'objectif. Fixation du parasoleil Il est conseillé d'utiliser un parasoleil pour réduire la lumière parasite et obtenir la meilleure image possible. Alignez la ligne rouge du parasoleil sur le point rouge de l'objectif (repère de parasoleil), puis insérez le parasoleil sur la monture d'objectif et tournez-le dans le sens horaire jusqu'à ce qu'il s'encliquette et le point rouge du parasoleil s'aligne sur le point rouge de l'objectif. ˎˎLorsque vous utilisez le flash intégré d'un appareil photo ou le flash fourni avec un appareil photo, retirez le parasoleil pour éviter de bloquer la lumière du flash. ˎˎPour ranger le parasoleil, insérez-le à l'arrière de l'objectif. Mise au point La mise au point peut être faite de trois façons. ˎˎAutofocus L'appareil photo fait automatiquement la mise au point. ˎˎDMF (Mise au point manuelle directe) Après la mise au point en autofocus, vous pouvez effectuer un réglage plus fin manuellement. ˎˎMise au point manuelle Vous faites vous-même la mise au point. Pour le détail sur les réglages de mode, reportezvous au mode d'emploi fourni avec l'appareil photo. Réglage de l'exposition Lorsque vous alignez « A » de l'échelle d'ouverture sur le repère d'ouverture, l'appareil photo est réglé en mode iris automatique et l'exposition est réglée par l'appareil photo. Vous pouvez régler la quantité de lumière entre f/1,4 et f/16 en tournant la bague d'ouverture. Réglage manuel de la quantité de lumière Faites pivoter la bague d'ouverture sur l'exposition voulue (f-stop) lorsque l'appareil photo est en mode M ou A. Remarques Réglez le commutateur d'encliquetage de l'ouverture sur OFF lors de l'enregistrement de vidéos. (Voir l'illustration -a.) Lorsque le commutateur d'encliquetage de l'ouverture est réglé sur OFF, le bruit émis par la bague d'ouverture est réduit. (Pour l'enregistrement de vidéos) Si vous changez la valeur d'ouverture pendant l'enregistrement d'une vidéo avec le commutateur d'encliquetage de l'ouverture réglé sur ON, le bruit émis par la bague d'ouverture sera enregistré. (Suite à la page arrière)