Sony SNCA-CFW5 Operating Instructions - Page 1
Sony SNCA-CFW5 Manual
View all Sony SNCA-CFW5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
3-218-128-02 (1) Wireless Card Operating Instructions Mode d'emploi Manual de instrucciones Bedienungsanleitung Istruzioni per l'uso SNCA-CFW5 2007 Sony Corporation Printed in China ґཔ͢Δɻ ͋Γ·͢ɻ DC 22cmҎͰ ༻͠ͳ͍ SNCA-CFW5 ϫΠϠϨεLAN LAN LAN 2.4GHz 1͔Β11 2.4GHz 1 2 3 2.4 DS/OF 4 2.4GHz DS-SS OFDM 40mͰ͢ɻ ֓ཁ SNCA-CFW5 LAN LAN PDA • 2.4GHz ද໘ A 1 2 SNCA-AN1 ཪ໘ B 3 MAC MAC: XXXXXX-XXXXXX MAC SN: XXXXXXX C F CompactFlash type II-PCMCIA PCΧʔυ ͝ҙ ओͳ༷ σʔλ ଐ ʵ0.3 ʙ 3.6 V 25 ʙ ʴ60 ˆ 3.0 ʙ 3.6 V 20 ʙ ʴ60 ˆ ࠷େ380 mA 2412ʙ2462 MHzʢνϟϯωϧ1ʙ11 0.11 dBi 6.4 dBi 2.8 dB 13 dBm 802.11b: ʵ80 dBm (PER 8e-2ɺ11 Mbps) 802.11g: ʵ65 dBm (PER 10e-2ɺ54 Mbps) 802.11b: 11ɺ5.5ɺ2ɺ1 Mbps 802.11g: 54ɺ48ɺ36ɺ24ɺ18ɺ12ɺ9ɺ 6 Mbps 1 1) 1ؒͰ͢ɻ English Owner's Record The model and serial numbers are located at the rear. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. SNCA-CFW5 Serial No. For the customers in the U.S.A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. If you have any questions about this product, you may call; Sony Customer Information Service Center 1-800-222-7669 or http://www.sony.com/ Declaration of Conformity Trade Name : SONY Model : SNCA-CFW5 Responsible party : Sony Electronics Inc. Address : 16530 Via Esprillo, San Diego, CA 92127 U.S.A. Telephone Number : 858-942-2230 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate the equipment. FCC Radiation Exposure Statement: This Transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. For customers in Canada This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. For customers in Europe Hereby, Sony Corporation, declares that this SNCACFW5/Wireless Card is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. For details, please access the follwing URL: http://www.compliance.sony.de/ Limitation for use in the EU This device can operate indoors or outdoors in all countries of the European Community using the 2.4GHz band: Channels 1 - 11, except where noted below: • In Italy, usage of the above mentioned device is regulated under Italian law: - D. Lgs 1.8.2003, n.259, art. 104 (activity subject to general authorization) and art. 105 (free usage), and for private usage; - D.M. 28/5/03, for providing to the general public access to R-LAN networks and services. • In France outdoor operation is only permitted using the 2.4 - 2.454 GHz band: Channels 1 - 7. Security on using wireless LAN products Security configuration is essential for wireless LAN. Should a problem occur without setting security, or due to the limitation of the wireless LAN specifications, Sony shall not be liable for any damage. If a problem occurs with this product as a result of defective manufacturing, Sony will replace it. However, Sony accepts no other responsibility. Warnings • In some situations or environments, the use of IEEE 802.11b/g technology may be restricted by the proprietor of the building or responsible representatives of the organization, for example on board of airplanes, in hospitals or in any other environment where the risk of interference with other devices or services is perceived or identified as harmful. • If you are uncertain about the policy applying to the use of IEEE 802.11b/ g technology in a specific organization or environment, you are encouraged to seek authorization before switching it on. • Consult your doctor or the manufacturer of personal medical devices (pacemakers, hearing aids, etc.) regarding any restrictions on the use of IEEE 802.11b/g technology. Introduction Sony SNCA-CFW5 Wireless Card allows you to connect the Network Camera to a Local Area Network from anywhere within the wireless coverage area. It also enables you to roam throughout the network while remaining connected to the LAN. This Wireless Card operates only with Sony Network Cameras. It cannot work properly with Laptop PCs, Desktop PCs, PDAs or other peripherals. The Wireless Card has an external antenna jack. The external antenna can expand communication distance. For details on the settings and operations of the camera for using the card, refer to the User's Guide supplied with the camera. Precautions on Use Handling the Wireless Card • Do not subject the card to excessive shock, and take care not to drop it to prevent malfunction. • Do not use or store the card in locations subject to: - extremely high temperature, such as in direct sunlight or near a heater - excessive dust - high humidity - vibrations - poor ventilation This may cause a malfunction. • Do not put a metal object such as a metal clip, etc. inside the card. • Do not use the card in an unstable place. • When inserting the card into the camera, take care not to force it in the wrong way. This may cause a malfunction. • When there is a device operating on the 2.4 GHz frequency band near the camera, the card and camera may not work correctly. The radio wave may go out of service or a poor connection may occur sometimes depending on the environment. • Always verify that the unit is operating properly before use. SONY WILL NOT BE LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO, COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS DUE TO FAILURE OF THIS UNIT, EITHER DURING THE WARRANTY PERIOD OR AFTER EXPIRATION OF THE WARRANTY, OR FOR ANY OTHER REASON WHATSOEVER. • If you lose data by using the Wireless Card, Sony accepts no responsibility for restoration of the data. Condensation Condensation is a phenomenon that occurs when moisture in the air turns into drops of water when it comes into contact with a metal plate, for example. Condensation may occur on the surface or inside the Wireless Card when you quickly move it from a cold place to a warm place, or when you turn on the heating in the room on a cold, winter morning. Using the Wireless Card with condensation on it may cause a malfunction. If condensation occurs on the Wireless Card, leave it without turning on the power of the camera until the condensation disappears. Location and Function of Parts Front A 1 Link indicator Flashes while the card is being initialized or the camera is being connected to the network. Remains lit when the connection to the network is established. 2 Antenna jack Connect the plug of the optional SNCA-AN1 antenna. Rear B 3 MAC address and Serial number MAC: XXXXXX-XXXXXX Indicates the MAC address of this card. SN: XXXXXXX Indicates the serial number of this card. Inserting the Wireless Card into the Camera Insert the Wireless Card into the CF card slot on the camera or insert it in a commercially available CompactFlash type II-PCMCIA adapter and then to the PC card slot of the camera. Notes • Insert the Wireless Card straight and fully into the card slot on the camera. • Do not insert the Wireless Card the wrong way. Forcing it in the wrong way will damage it and cause a malfunction. • If the camera failed to identify the Wireless Card, remove the card from the camera and insert it again. • During communication, do not remove the Wireless Card or subject the camera to excessive shock. Removing the Wireless Card After use, stop all communication. Then, pull the Wireless Card straight out. Specifications Absolute maximum ratings Supply voltage -0.3 to 3.6 V (max.) Storage temperature -25 to +60 °C (-13 to +140 °F) (All temperature references refer to ambient conditions) Operating conditions Supply voltage range Temperature range 3.0 to 3.6 V (max.) -20 to +60 °C (-4 to +140 °F) Electrical Specifications Current consumption 380 mA max. (In transmission) Center frequency range 2412 to 2462 MHz (1-11ch) Antenna Gain Internal: 0.11 dBi max. External-polarity: 6.4 dBi max. (Including Transmitter power cable loss 2.8 dB) +13 dBm max. Receiving sensitivity 802.11b: -80 dBm (PER 8e-2, at 11 Mbps) 802.11g: -65 dBm (PER 10e-2, at 54 Data rate Mbps) 802.11b: 11, 5.5, 2, 1 Mbps Supplied accessory 802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps Operating Instructions (this document) (1) Design and specifications are subject to change without notice. Français Pour les utilisateurs au Canada Cet appareil numérique de la classe B est conforme à la norme NMB003 du Canada. L'utilisation doit répondre aux deux conditions suivantes : (1) ce matériel ne doit pas provoquer de brouillage et (2) il doit accepter tout brouillage, même celui qui est susceptible d'affecter son fonctionnement. Déclaration d'exposition aux radiations des IC : Cet appareil est conforme aux limites d'exposition aux radiations des IC RSS-102 établies pour un environnement non contrôlé. Pour l'installation et l'utilisation de cet appareil, il convient de prévoir une distance minimum de 20 cm entre le radiateur et votre corps. Pour les utilisateurs en Europe Par la présente Sony Corporation déclare que l'appareil SNCA-CFW5/Wireless Card est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 1999/5/CE. Pour toute information complémentaire, veuillez consulter l'URL suivante: http://www.compliance.sony.de/ Restriction d'utilisation au sein de l'Union européenne Cet appareil peut être utilisé à l'intérieur ou à l'extérieur dans tous les pays de la Communauté européenne en utilisant la bande de fréquences 2,4 GHz : canaux 1 à 11, à l'exception des endroits mentionnés ci-dessous : En France, l'utilisation à l'extérieur est autorisée uniquement si vous utilisez la bande de fréquences 2,4 à 2,454 GHz : canaux 1 à 7. Précautions de sécurité lors de l'utilisation de produits LAN sans fil La configuration de la sécurité est essentielle à une utilisation correcte des produits LAN sans fil. Si un problème se produit sans que vous ayez activé la sécurité ou en raison de la limitation des spécifications LAN sans fil, Sony ne pourra être tenue responsable de quelque dommage que ce soit. Si vous rencontriez un problème avec cet appareil en raison d'un défaut de fabrication, Sony le remplacera. Toutefois, Sony n'assume aucune autre responsabilité. Avertissements • Dans certaines situations ou environnements, l'utilisation de la technologie IEEE 802.11b/g peut être limitée par le propriétaire du bâtiment ou les représentants responsables de l'organisation, par exemple à bord d'un avion, dans les hôpitaux ou dans tout autre environnement où le risque d'interférence avec d'autres appareils ou services est considéré ou identifié comme nuisible. • Si vous hésitez quant à la politique à adopter pour l'utilisation de la technologie IEEE 802.11b/g dans une organisation ou un environnement spécifique, nous vous conseillons d'obtenir toutes les autorisations nécessaires avant toute mise en route. • Consultez votre médecin ou le fabricant d'appareils médicaux personnels (stimulateurs cardiaques, prothèses auditives, etc.) concernant les restrictions d'utilisation de la technologie IEEE 802.11b/g. Introduction La carte sans fil Sony SNCA-CFW5 vous permet de raccorder la caméra réseau à un réseau local (LAN) où que vous vous trouviez dans la zone de couverture sans fil. Elle vous permet également de vous déplacer dans le réseau tout en restant connecté au LAN. Cette carte sans fil fonctionne exclusivement avec les caméras réseau Sony. Les ordinateurs portables, de bureau, PDA ou autres périphériques ne peuvent pas fonctionner correctement avec cet appareil. La carte sans fil dispose d'une prise d'antenne externe. L'antenne externe peut augmenter la distance de communication. Pour obtenir plus de détails sur les réglages et le fonctionnement de la caméra avec la carte, reportez-vous au mode d'emploi fourni avec la caméra (suite au verso) A 2B 3 1