Sony SS-HA3 Operating Instructions - Page 1

4-475-026-11(3) Speaker System Operating Instructions Mode d'emploi Manual de instrucciones Connection/Raccordement/Conexión Right Droit Derecho + terminal (red) Borne + (rouge) Terminal + (rojo) Left Gauche Izquierdo - terminal (black) Borne - (noire) Terminal - (negro) Amplifier Amplificateur Amplificador Speaker cord (supplied) Cordon d'enceinte (fourni) Cable del altavoz (suministrado) Speaker cord (supplied) Cordon d'enceinte (fourni) Cable del altavoz (suministrado) ˎˎOutput power of your receiver or amplifier must not be over the maximum input power of the speaker system, and an appropriate volume level to prevent sound distortion must be kept. See "Specifications" for the maximum input power. ˎˎLa puissance de sortie de votre récepteur ou de votre amplificateur ne pas doit être supérieure à la puissance d'entrée maximum du système d'enceintes, et vous devez maintenir le volume à un niveau approprié afin d'éviter la distorsion. Voir la section « Spécifications » pour connaître la puissance d'entrée maximum. ˎˎLa potencia de salida del receptor o el amplificador no debe sobrepasar la potencia máxima de entrada del sistema de altavoces, por lo que, para evitar la distorsión del sonido, se debe ajustar un volumen apropiado. Puede consultar la potencia máxima de entrada en "Especificaciones". SS-HA1/HA3 English Owner's Record The model and serial numbers are located on the bottom of the unit. Record the serial numbers in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No Serial No Features The forward-facing and upward-facing super tweeter configuration achieves a multidirectional listening experience. Uniquely shaped front panels with boldly cut edges also help prevent sound diffraction. That way, high-quality sound from sound sources or CDs can be enjoyed in wider area than with conventional speakers. Connections ˎˎBefore connecting, turn off the amplifier to avoid damaging the speaker system. ˎˎWhen turning the amplifier or program source power on/off, reduce the sound level on the amplifier to minimum. ˎˎWhen bass sound is missing or the sound output position of musical instruments is not distinct, make sure the +/- terminals of speaker cords are connected properly. Precautions ˎˎAvoid driving the speaker system continuously with a wattage exceeding the maximum input power of each speaker. ˎˎDo not place anything on the speakers. ˎˎDo not attempt to open the enclosure or remove speaker units. There are no user-serviceable parts inside. © 2013 Sony Corporation Printed in China ˎˎKeep recorded tapes, watches, personal credit cards, and hard disk drives using magnetic coding away from the speaker system. ˎˎThe speaker system has been tuned without the grill on. Remove the grill before using the speaker system. Cleaning and maintenance ˎˎTo avoid damaging the enclosure, do not use thinner, alcohol, benzene, etc. ˎˎTo keep a good gloss on the enclosure, dust it first using a soft cloth, a brush, or a feather duster and then polish it using a dry cleaning cloth (never use a scrubbing brush or a sponge). ˎˎWipe the surface gently. For fingerprints or oil stains, etc., breathe on the surface and wipe it off with a cleaning cloth. ˎˎIf the enclosure becomes extremely dirty, wipe the enclosure using a soft cloth slightly moistened with a soap and water mix. ˎˎBe careful not to scratch the surface of the enclosure. ˎˎWipe dust and other dirt from the super tweeter (top panel) using a blower brush or soft brush. Speaker Placement ˎˎPlease note that room acoustics can often produce large difference in the sound for small changes in speaker placement. ēēPlace the speaker system against a hard wall with its back about 20 cm away from a wall. ēēPlace the right and left speakers in a similar acoustic environment. ˎˎDo not place the speaker system in the following places: ēēAnywhere that is extremely hot or under direct sunlight ēēAnywhere that is dusty ēēAnywhere that is extremely humid ēēNear a player ēēIn a cabinet, especially one above your line of sight Specifications SS-HA1 Speaker system 3 way, 4 drivers speaker system Loud speaker units Woofer: 13 cm (5 3/4 in.), cone type (1) Tweeter: 2.5 cm (1 in.), soft dome type (1) Super tweeter: 1.9 cm (3/4 in.), soft dome type (2) Enclosure type Bass reflex Rated impedance 4 ohms Maximum input power 100 watts Sensitivity level 86 dB (2.83 V, 1 m) Effective Frequency Range 48 Hz - 50 kHz Dimensions (w/h/d) Approx. 185 mm × 312 mm × 312 mm (7 3/8 in. × 12 3/8 in. × 12 3/8 in.) Mass Approx. 4.8 kg (10 lb. 9 oz.) Supplied accessories Speaker cords (2) Operating Instructions (1) SS-HA3 Speaker system Loud speaker units Enclosure type Rated impedance Maximum input power Sensitivity level Frequency range Dimensions (w/h/d) Mass Supplied accessories 2 way, 3 drivers speaker system Woofer: 10 cm (4 in.), cone type (1) Super tweeter: 1.9 cm (3/4 in.), soft dome type (2) Bass reflex 4 ohms 70 watts 83 dB (2.83 V, 1 m) 55 Hz - 50 kHz Approx. 150 mm × 231 mm × 232 mm (6 in. × 9 1/8 in. × 9 1/8 in.) Approx. 3.1 kg (6 lb. 13 oz.) Speaker cords (2) Operating Instructions (1) Design and specifications are subject to change without notice.