Sony STR-DA5300ES Operating Instructions (Large File - 21.32 MB) - Page 51

Getting Started Message list after auto calibration measurement Display Explanation Code 30 Headphones are connected. Remove the headphones and perform the auto calibration again. Code 31 SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and re-perform the measurement. Code 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and reperform the measurement. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected. Code 33 • None of the front speakers are connected or only one front speaker is connected. • The optimizer microphone is not connected. • Either the left or right surround speakers is not connected. • Surround back speakers are connected even though surround speakers are not connected. Connect the surround speaker(s) to the SURROUND terminals. • The surround back speaker is connected only to the SURROUND BACK SPEAKERS R terminals. When you connect only one surround back speaker, connect it to the SURROUND BACK SPEAKERS L terminals. Code 34 Speakers are not placed in the proper position. Speakers or an optimizer microphone on the right or left may be placed wrongly. See "1: Installing speakers" (page 16) and check the speaker position. Warning 40 The measurement has completed. However, the noise level is high. You may be able to perform the measurement properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the measurement in a quiet environment. Warning 41 The sound input from the optimizer microphone is outside the acceptable range. It is louder than the loudest sound that can be measured. Try to perform the measurement when the environment is quiet enough to allow proper measurement. Warning 42 The volume of the receiver is out of the acceptable range. Try to perform the measurement when the environment is quiet enough to allow proper measurement. Warning 43 The distance and position of a sub woofer cannot be detected. Or the angle of the speaker position cannot be detected. This may be caused by noise. Try to perform the measurement in a quiet environment. Warning 44 Measurement has been completed. However the speakers are not placed in the proper position with respect to each other. See "1: Installing speakers" (page 16) and check the relative positions of the speakers. NO WARNING There is no warning information. ---------- No speakers are connected. •Code 31 1 Press , then follow the instructions from step 1 of "Performing auto calibration." •Code 32, 33, 34 1 When you press , "Retry?" appears. 2 Press B/b to select "Yes," then press . 3 Follow the instructions from step 2 of "Performing auto calibration." When you select "WRN CHECK" If a warning on the measurement result is present, detailed information is displayed. Press to return to step 1 of "Confirming/saving the measurement results" (page 49). continued 51GB