Sony STR-DE597 Operating Instructions - Page 49

Specifications - protect mode

Page 49 highlights

Error messages If there is a malfunction, the display shows a message. You can check the condition of the receiver by the message. Refer to the following table to solve the problem. DEC. EROR Appears when the signal which the receiver cannot decode (ex. DTS-CD) is input when "DEC. XXXX" is set to "DEC. PCM". Set to "DEC. AUTO". PROTECT Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again. If this problem persists, consult your nearest Sony dealer. If you are unable to remedy the problem using the troubleshooting guide Clearing the receiver's memory may remedy the problem (page 17). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver. If the problem persist Consult your nearest Sony dealer. Reference sections for clearing the receiver's memory To clear All memorized settings Customized sound fields See page 17 page 36 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 90 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Power Output Models of area code U, CA Rated Power Output at Stereo Mode (8 ohms 20 Hz - 20 kHz, THD 0.09%) 90 W + 90 W1) Reference Power Output1) (8 ohms 20 Hz - 20 kHz, THD 0.09%) FRONT2): CENTER2): 90 W/ch 90 W SURR2): 90 W/ch SURR BACK2): 90 W (8 ohms 1 kHz, THD 0.7%) FRONT2): 100 W/ch CENTER2): 100 W SURR2): 100 W/ch SURR BACK2): 100 W Models of area code CEL, CEK Rated Power Output at Stereo Mode (8 ohms 1 kHz, THD 0.7%) 100 W + 100 W1) Reference Power Output1) (8 ohms 1 kHz, THD 0.7%) FRONT2): 100 W/ch CENTER2): SURR2): 100 W 100 W/ch SURR BACK2): 100 W Models of area code E2/E3, TW Rated Power Output at Stereo Mode (8 ohms 1 kHz, THD 0.7%) 100 W + 100 W1) Reference Power Output1) (8 ohms 1 kHz, THD 10%) FRONT2): 120 W/ch CENTER2): 120 W SURR2): SURR BACK2): 120 W/ch 120 W continued 49GB Additional Information

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

Additional Information
49
GB
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when
DEC. XXXX
is set to
DEC. PCM
. Set to
DEC. AUTO
.
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver
s memory may remedy the
problem (page 17). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver
s memory
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20
20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
Models of area code U, CA
Rated Power Output at Stereo Mode
(8 ohms 20 Hz
20 kHz, THD 0.09%)
90 W + 90 W
1)
Reference Power Output
1)
(8 ohms 20 Hz
20 kHz, THD 0.09%)
FRONT
2)
:
90 W/ch
CENTER
2)
:
90 W
SURR
2)
:
90 W/ch
SURR BACK
2)
:
90 W
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
:
100 W/ch
CENTER
2)
:
100 W
SURR
2)
:
100 W/ch
SURR BACK
2)
:
100 W
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output
1)
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
:
100 W/ch
CENTER
2)
:
100 W
SURR
2)
:
100 W/ch
SURR BACK
2)
:
100 W
Models of area code E2/E3, TW
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output
1)
(8 ohms 1 kHz, THD 10%)
FRONT
2)
:
120 W/ch
CENTER
2)
:
120 W
SURR
2)
:
120 W/ch
SURR BACK
2)
:
120 W
To clear
See
All memorized settings
page 17
Customized sound fields
page 36
Specifications
continued