Sony STR-DE625 User Instructions - Page 11

Ho o k i n g Up t h e Co m p o n e n t s CONTROL S hookup (STR-DE625 only) If you have a CONTROL S-compatible Sony TV, DBS tuner, monitor, or VCR, use an audio/video/control S connecting cord (supplied) or a control S connecting cord (supplied) to connect the CTRL S (STATUS) IN (for TV, DBS tuner, or monitor) or OUT (for VCR etc.) jack on the receiver to the appropriate S-LINK jack on the respective component. Refer to the operating instructions supplied with your TV, DBS tuner, monitor, VCR, etc., for details. An example of a CONTROL S hookup between the receiver and TV or VCR is shown below. When your TV is connected to the receiver as shown below, the TV input mode will change to video input whenever you turn on the receiver. When you connect the VCR to the receiver as shown below, the input mode of the receiver changes to video 1 (or 2) whenever you turn on the VCR. TV AUDIO OUT L R S-LINK IN OUT VIDEO IN Receiver * TV / DBS CTRL S STATUS IN VIDEO IN ** * VIDEO 1 CTRL S OUT S-LINK MONITOR CTRL S IN VIDEO VIDEO VIDEO OUT IN OUT AUDIO IN L R AUDIO AUDIO OUT IN L R VCR S-LINK OUT * OUTPUT VIDEO OUT AUDIO OUT L R * Audio/video/control S connecting cord ** Control S connecting cord CONTROL A1 hookup (STR-DE625 only) • If you have a CONTROL A1-com pat ible Sony CD p l a y e,r t a p e d e ck , o r M D d e ck Use a CONTROL A1 cord (not supplied) to connect the S-LINK CTRL A1 jack on the CD player, tape deck, or MD deck to the S-LINK CTRL A1 jack on the receiver. See "Displaying the operating status of the component connected to the S-LINK CTRL A1 jack" on page 36 and refer to the separate manual "CONTROL-A1 Control System" and the operating instructions supplied with your CD player, tape deck, or MD deck for details. • I f y o u h a v e a So n y CD ch a n g e r w i t h a COM M AND M ODE select or If your CD changer's COMMAND MODE selector can be set to CD 1, CD 2, or CD 3, be sure to set the command mode to "CD 1" and connect the changer to the CD jacks on the receiver. If, however, you have a Sony CD changer with VIDEO OUT jacks, set the command mode to "CD 2" and connect the changer to the VIDEO 2 jacks on the receiver. Set t ing t he volt age select or (only on m odels supplied w it h a volt age select or) Check that the voltage selector on the rear panel of the receiver is set to the local power supply voltage. If not, use a screwdriver to set the selector to the correct position before connecting the AC power cord to a wall outlet. VOLTAGE SELECT 220V 240V 120V 11