Sony STR-DE985 Operating Instructions - Page 25
Checking the connections - remote
View all Sony STR-DE985 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Hooking Up and Setting Up the Speaker System Adjusting the speaker level Use the remote while seated in your listening position to adjust the level of each speaker. Note The receiver incorporates a new test tone with a frequency centered at 800 Hz for easier speaker level adjustment. 1 Press ?/1 to turn on the receiver. 2 Press TEST TONE on the remote. "TEST TONE" appears in the display and you will hear the test tone from each speaker in sequence. 3 To change the test tone mode, press B/b to select the mode you want. Mode The test tone output NORMAL The test tone is output from each speaker in sequence. PHASE The test tone is output from two speakers at a time in sequence. (There is no sound output from the sub woofer.) You can also adjust the balance between speakers. 2CH SWAP* You can adjust the speaker levels while listening to the source (not the test tone). Turn on the connected component, start playback, then turn FUNCTION to select the component (except when connected to the MULTI CH IN** jacks). The sound for the front L/R speakers is output from the surround R/L speakers. You can adjust the level of surround speakers from the listening position. * You cannot select "2CH SWAP" when "2CH ANALOG DIRECT" is selected (page 27). ** For STR-DE985, MULTI CH IN 1 or 2. 4 Adjust the LEVEL parameters so that the level of the test tone from each speaker sounds the same when you are in your main listening position. Press LEVEL to adjust the balance and level of speakers. For details on the LEVEL menu, see page 37. While adjusting, the test tone is output from the speaker whose adjustment is performed. 5 Press TEST TONE again to turn off the test tone. Tips • You can adjust the level of all speakers at the same time. Turn MASTER VOLUME on the main unit or press MASTER VOL +/- on the remote. • In step 3, you can select the mode using the jog dial on the receiver. Notes • The adjusted value are shown in the display during adjustment. • Although these adjustments can also be made via the front panel using the LEVEL menu (when the test tone is output, the receiver switches to the LEVEL menu automatically), we recommend you follow the procedure described above and adjust the speaker levels from your listening position using the remote. Checking the connections After connecting all of your components to the receiver, do the following to verify that the connections were made correctly. 1 Press ?/1 to turn on the receiver. 2 Turn on the component that you connected (e.g., CD player or tape deck). 3 Rotate FUNCTION to select the component (program source). 4 Start playing. If you do not obtain normal sound output after performing this procedure, see "Troubleshooting" on page 58 and take the appropriate measures to correct the problem. 25US