Sony STR-DH740 Operating Instructions - Page 62
Crossover Freq. Speaker, crossover frequency, Test Tone, Distance Unit, Large, Small, meter - best speakers
View all Sony STR-DH740 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
• Large: If you connect large speakers that will effectively reproduce bass frequencies, select "Large". Normally, select "Large". • Small: If the sound is distorted, or you feel a lack of surround effects when using multi channel surround sound, select "Small" to activate the bass redirection circuitry and output the bass frequencies of each channel from the subwoofer or other "Large" speakers. Note This function does not work when "Analog Direct" is being used. Tips • The "Large" and "Small" settings for each speaker determine whether the internal sound processor will cut the bass signal from that channel. When the bass is cut from a channel, the bass redirection circuitry sends the corresponding bass frequencies to the subwoofer or other "Large" speakers. However, since bass sound has a certain amount of directionality, it is best not to cut it, if possible. Therefore, even when using small speakers, you can set them to "Large" if you want to output the bass frequencies from that speaker. On the other hand, if you are using a large speaker, but prefer not to have bass frequencies output from that speaker, set it to "Small". If the overall sound level is lower than you prefer, set all speakers to "Large". If there is not enough bass, you can use the equalizer to boost the bass levels. • The surround back speakers will be set to the same setting as that of the surround speakers. • When the front speakers are set to "Small", the center, surround, and surround back/front high speakers are also automatically set to "Small". • If you do not use the subwoofer, the front speakers are automatically set to "Large". x Crossover Freq. (Speaker crossover frequency) Lets you set the bass crossover frequency of speakers that the speaker size has been set to "Small" in the Speaker Settings menu. Measured speaker crossover frequency is set for each speaker after the Auto Calibration. 1 Select the speaker parameter under the speaker which you want to adjust the crossover frequency, then press . 2 Adjust the value, then press . x Test Tone Lets you select the test tone type on the "Test Tone" screen. Tips • To adjust the level of all speakers at the same time, press 2 +/-. You can also use MASTER VOLUME on the receiver. • The adjusted value is shown on the TV screen during adjustment. To output test tone from each speaker You can output test tone from the speakers in sequence. 1 Select "Test Tone", then press . 2 Select "Test Tone" again, then press . 3 Adjust the parameter, then press . • Off • Auto: The test tone is output from each speaker in sequence. 4 Select the speaker which you want to adjust the speaker level, then press . 5 Adjust the level of the selected speaker, then press . x Distance Unit Lets you select the unit of measurement for setting distances. • feet: The distance is displayed in feet. • meter: The distance is displayed in meters. 62GB