Sony STR-K4800P HT4800DP Instructions (main HT model) - Page 19
Listening to FM/AM radio, Amplifier Operation - remote codes
View all Sony STR-K4800P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Amplifier Operation Listening to FM/AM radio You can listen to FM and AM broadcasts through the built-in tuner. Before operation, make sure you have connected the FM and AM antennas to the receiver (see page 11). Tip The tuning scale differs depending on the area code as shown in the following table. For details on area codes, see page 3. Area code U, CA FM 100 kHz AM 10 kHz* * The AM tuning scale can be changed (see page 43). Automatic tuning If you do not know the frequency of the station you want, you can let the receiver scan all available stations in your area. 1 Press TUNER FM/AM repeatedly to select the FM or AM band. The last received station is tuned in. 2 Press TUNING + or TUNING -. Press TUNING + to scan from low to high; press TUNING - to scan from high to low. The receiver stops scanning whenever a station is received. Tip If "STEREO" flashes in the display and the FM stereo reception is poor, press FM MODE to change to monaural (MONO). You will not be able to enjoy the stereo effect, but the sound will be less distorted. To return to stereo mode, press FM MODE again. Direct tuning You can enter the frequency of the station you want directly. Use the remote for the operation. 1 Press TUNER repeatedly to select the FM or AM band. The last received station is tuned in. Tip You can also use TUNER FM/AM on the receiver. 2 Press D.TUNING. 3 Press the numeric buttons to enter the frequency. Example 1: FM 102.50 MHz Press 1 b 0 b 2 b 5 b 0 Example 2: AM 1,350 kHz (You do not have to enter the last "0" when the tuning scale is set to 10 kHz.) Press 1 b 3 b 5 b 0 If you have tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception. If you cannot tune in a station and the entered numbers flash Make sure you have entered the right frequency. If not, repeat steps 2 and 3. If the entered numbers still flash, the frequency is not used in your area. 19US