Sony STR-KS370 Operating Instructions - Page 27

The table below shows the display when measurement starts. Measurement for Speaker existance Speaker gain, distance, frequency response Subwoofer gain and distance Display TONE T. S. P. SUBWOOFER Notes • If "CHECK MIC" appears, you cannot perform the Auto Calibration. Connect the optimizer microphone, then perform the Auto Calibration again. • If "PHONES" appears, you cannot perform the Auto Calibration. Disconnect the headphones from the S-AIR product you are using, then perform the Auto Calibration again. Tips • When Auto Calibration starts: - Stand some distance from the speakers and the listening position to avoid measurement failure. This is because test signals are output from the speakers during measurement. - Avoid making noise to get a more accurate measurement. • The Auto Calibration function will be canceled when you do the following during the measurement process: - Press ?/1 or MUTING. - Press input buttons on the remote or INPUT SELECTOR +/- on the receiver. - Change the volume level. Confirming/saving the measurement results 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement Display Explanation result When the measurement process completes properly SAVE EXIT Proceed to step 2. When the measurement process fails ERROR XXXX See "When error codes appear" (page 28). 2 Press V/v repeatedly to select the item, then press . Item Explanation SAVE EXIT Saves the measurement results and exits the setting process. WRN CHECK Displays warning concerning the measurement results. See "When you select "WRN CHECK"" (page 28). DIST INFO Displays the measurement result for speaker distance. LEVEL INFO Displays the measurement result for speaker level. EXIT Exits the setting process without saving the measurement results. Note After "SAVE EXIT" is displayed for 50 seconds, the measurement result is saved automatically, without the need to save the procedure. 3 Save the measurement result. Select "SAVE EXIT" in step 2. The measurement results are saved. continued 27US Getting Started