Sony SU-HS1 Mounting Instructions - Page 4

A 1 3 B A 2 Lower support Pedestal 4 Adjuster Upper support Stopper C English The SU-HS1 is a Projector Stand for the LCD Video Projector only. Assemble the Projector Stand and adjust it as follows: Assembling the Projector Stand A Before assembling Remove the adjuster mounted on the LCD Video Projector. To remove it, refer to the Video Projector Operating Instructions. 1 Pass a lower support part through the hole of a pedestal, then fix it with the supplied 4 long screws. 2 Mount a upper support part and stopper to the lower support part and adjust it height, then fix it. 3 Pass a AC power cord and PJ Multi cable through the supports. Pull out the cables from the top of the upper support for 20 to 30 cm so that they reach to the projector. 4 Store the cables into the groove at the back of the adjuster, and fix the adjuster to the support with the four short screws. 5 Connect the cables passed through the supports to the projector. Adjusting the adjuster B Using the adjuster of the projector stand, you can adjust the projecting picture position. Hold down and slide the adjuster stopper to the right, move the projector, then replace the stopper. B Adjuster stopper 55 - 80 cm You can move the projector vertically and horizontally within the following ranges: A Up to 20° each for horizontal angle B Up to 10° each for vertical angle C Up to 2° each for tilting angle C Adjusting the height of the supports C You can adjust the height of the supports within the following range: 55 to 80 cm (Distance between the center of the lens and the floor) Specifications Dimensions: 420 × 420 × 750mm (W × D × H) Mass: Approx. 5.5 kg (13 lb) 4