Sony TRV18 Operating Instructions - Page 185
Types of trouble and how to correct, trouble - service manual
UPC - 027242603219
View all Sony TRV18 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
- Troubleshooting - Types of trouble and how to correct trouble If you run into any problem using your camcorder, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact your Sony dealer or local authorized Sony service facility. If "C:ss:ss" appears on the screen, the self-diagnosis display function has worked. See page 191. In the recording mode Symptom Cause and/or Corrective Actions START/STOP does not operate. • The POWER switch is not set to CAMERA. c Set it to CAMERA. (p. 26) • The cassette has run out. c Rewind the tape or insert a new one. (p. 25, 40) • The write-protect tab is set to expose the red mark. c Use a new tape or slide the tab. (p. 25) • The tape is stuck to the drum (moisture condensation). c Remove the cassette and leave your camcorder for at least one hour to acclimatize. (p. 202) The power goes off. • While being operated in CAMERA, your camcorder has been in the standby mode for more than five minutes. c Set the POWER switch to OFF (CHG) and then to CAMERA. • The battery pack is dead or nearly dead. c Install a charged battery pack. (p. 16) The image on the viewfinder screen • The viewfinder lens is not adjusted. is not clear. c Adjust the viewfinder lens. (p. 29) The SteadyShot function does not work. • STEADYSHOT is set to OFF in the menu settings. c Set it to ON. (p. 177) The autofocusing function does not work. • The setting is the manual focus. c Press FOCUS/INFINITY to set to the autofocus mode. (p. 61) • Shooting conditions are not suitable for autofocus. c Adjust for manual focusing. (p. 61) The picture does not appear in the viewfinder. • The LCD panel is open. c Close the LCD panel. (p. 28) A vertical band appears when you shoot a subject such as lights or a candle flame against a dark background. • The contrast between the subject and background is too high. This is not a malfunction. A vertical band appears when you shoot a very bright subject. • This is not a malfunction. Some tiny white, red, blue or green spots appear on the screen. • Slow shutter, Super NightShot or Color Slow Shutter is activated. This is not a malfunction. An unknown picture is displayed on the screen. • If 10 minutes elapse after you set the POWER switch to CAMERA or DEMO MODE is set to ON in the menu settings without a cassette and a "Memory Stick" inserted, your camcorder automatically starts the demonstration. c Insert a cassette or a "Memory Stick" and the demonstration stops. You can also cancel DEMO MODE. (p. 183) (continued on the following page) Troubleshooting 185