Sony VGN-FE650FM Help - Page 1

VGN-FE Series Hard Disk Drive Replacement Instructions IMPORTANT! PLEASE READ BEFORE YOU START These easy instructions are intended to guide you through the replacement process. ü To avoid electric shock, please make sure product is turned off and AC Adaptor is disconnected from the power source. Remove jewelry before you begin work to avoid scratching the surface of your notebook computer.* ü Place your notebook computer on a clean, stable and covered surface to avoid damage to the computer's case.* ü Follow the ESD (Electrostatic Discharge) damage prevention instructions: o Hold parts by the edges, away from exposed circuitry when possible. o Do not walk around excessively as this promotes static build-up. ü The appearance of the electronic components shown in the illustrations may be different from the components shipped. This slight difference does not affect the accuracy of these instructions. * Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of the computer under these procedures. The terms of your Sony limited warranty continue to apply. Push tabs in the release direction Step 1. Prepare the Computer. Step 2. Remove the Battery Pack. Step 3. Locate HDD Bay. CAUTION: Make sure the computer is turned off, the lid is closed, and the AC Adapter is disconnected. Failure to do so can result in damage to the computer. Place the computer upside down on a protected surface with the front edge facing you. Locate the two tabs as shown in the picture. One is on the left end of the battery pack, and the other is located on the right side. Using your thumbs and fingers push both tabs in the release direction; gently push the battery pack away from you. Rotate the computer with the Hard Disk Drive (HDD) bay facing you as shown in the picture. P/N 994636700 Rev. C 1/2