Sony VGP-UHDM08 Operating Instructions - Page 12

Disconnecting the drive from the computer, Click the, icon on the taskbar.

Page 12 highlights

Disconnecting the drive from the computer Follow the procedure below to disconnect this drive from your computer. (The following procedures are for Windows XP.) Notes • Before disconnecting the drive, close any open programs. • If the message below appears when you attempt to disconnect the drive, close any running software, wait for a while and then repeat the procedure. "Problem Ejecting USB Mass Storage Device. The device 'Generic Volume' cannot be stopped right now. Try stopping the device again later". z Tip To use the drive again after disconnecting the USB cable, perform the steps described in the section "Getting Started" on page 8. The drive will be detected automatically by your Windows operating system. The icon appears on the taskbar when the drive is recognized by the computer. To disconnect the drive from the computer, use the icon. 1 Click the icon on the taskbar. The "Safely remove USB Mass Storage Device" message appears. 2 Click "Safely remove USB Mass Storage Device". The message "The 'USB Mass Storage Device' device can now be safely removed from the system" appears. 3 Disconnect the USB cable. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27

12
Disconnecting the drive from the computer
Follow the procedure below to disconnect this drive from your computer.
(The following procedures are for Windows XP.)
Notes
Before disconnecting the drive, close any open programs.
If the message below appears when you attempt to disconnect the drive, close any
running software, wait for a while and then repeat the procedure.
“Problem Ejecting USB Mass Storage Device. The device ‘Generic Volume’ cannot be
stopped right now. Try stopping the device again later”.
z
Tip
To use the drive again after disconnecting the USB cable, perform the steps described in
the section “Getting Started” on page 8. The drive will be detected automatically by your
Windows operating system.
The
icon appears on the taskbar when the drive is recognized by the
computer. To disconnect the drive from the computer, use the
icon.
1
Click the
icon on the taskbar.
The
“Safely remove USB Mass Storage Device” message appears.
2
Click “Safely remove USB Mass Storage Device”.
The message “The ‘USB Mass Storage Device’ device can now be
safely removed from the system” appears.
3
Disconnect the USB cable.