Sony VPL-DX271 Operating Instructions - Page 31
Messages List
View all Sony VPL-DX271 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Messages List When any of the messages listed below appears on the projected image, address the problem in accordance with the table below. Messages Meaning/Remedy Page Please clean the filter. Clean the air filter. 36 Please replace the Lamp Replace the lamp with a new one and clean the air filter. The and clean the Filter. message appears whenever you turn on the power until you replace the lamp and reset the lamp timer. 34, 36 High temp.! Lamp off in 1 min. A temperature rise is detected in the unit. Follow the following instructions. • Check if the air filter is clogged, then clean or replace it. • Check if the ventilation holes (intake/exhaust) are not blocked by walls, etc., then keep enough space around the unit. • Check the ambient temperature around the unit. Use the unit within the operating temperature range. 3, 3, 27, 36 Frequency is out of range! Change the output setting of the connected equipment to one 43 for signals supported by the projector. Please check Input-A Set "Input-A Signal Sel." to "Auto" or select the input signal 25 Signal Sel. type to suit to the input signal. Not applicable! Invalid key was pressed. - The control keys are "Control Key Lock" is set to "On." 24 locked! Projector will shutdown The ?/1 key was pressed and the projector will be shut down 15 soon soon. To cancel shutdown, press the ?/1 key again (the Press ?/1 Key to Restart projector will remain on). To turn off the projector directly, press and hold the ?/1 key for a few seconds. Lamp Dimming Reduces lamp output when "With Static Signal" is set. When 25 any change in signal is detected, or an operation (remote control or control panel) is performed, normal brightness is restored. Others Messages List 31