Sony XCEI50 User Manual (XCES_Series_User_Guide) - Page 27

XC-E series TIMING CHART OF EXTERNAL TRIGGER SHUTTER - MODE 1 (NON-RESET MODE) For setting the shutter speed using DIP switch HD/VD input • Continuous HD/VD input *1 Trigger *1 External HD *1 External VD (Continuous VD) External trigger shutter operation 1 2 *2 Exposure time Te *2 Exposure time Te *4 T : T = Under 10 ms *4 T : T = 10 ms or more Video out 1 2 *3 Normal operation Mode transition state External input inhibition area External trigger (50 ms) shutter operation *3 Trigger 3 *2 Exposure time Te *4 T : T = 10 ms or more 3 WEN 250H (XC-ES50/ES30, XC-EI50/EI30) 293H (XC-ES50CE/ES30CE, XC-EI50CE/EI30CE) 250H (XC-ES50/ES30, XC-EI50/EI30) 293H (XC-ES50CE/ES30CE, XC-EI50CE/EI30CE) *1: This is a signal input from the outside. The period of a continuous VD signal is prescribed as one field. Be sure to input both HD and VD signals. *2: As shown in the table on page 7, exposure time Te is determined by the setting of a DIP switch. *3: The normal operation state is engaged when the high period exceeds 1/3 sec. After that, the external trigger shutter operation is engaged when the trigger pulse goes "low". In this case, the area between the falling edge of a trigger pulse and the subsequent 50 ms period is an external input inhibition area. During the trigger inhibit period, an input trigger may be missed. *4: An image is output when an external VD signal falls 10 ms or more after a trigger pulse rises (shown by 2 and 3 in the figure). If the time (T in the figure) between the falling edges of a trigger pulse and external VD signal is under 10 ms, an image is output when the external VD signal or the next external VD signal falls (as shown by 1 in the figure). (In this case, an image is output when the next external VD signal falls.) An image and WEN signal are always output together. For more details, refer to the WEN signal. Note : An image is superimposed when the next exposure ends before the previous image is output. 25