Sony XM-GTR2202 Marketing Specifications - Page 2

XM-GTR2202 Features 220 Watts x 2 RMS at 4 Ohms1 440 Watts x 2 max power at 4 Ohms 270 Watts x 2 RMS at 2 Ohms 650 Watts x 2 max power at 2 Ohms 540 Watts x 1 RMS at 4 Ohms 1400 Watts x 1 max power at 4 Ohms This unit can be used as a bridging amplifier with a maximum output of 1400 Watts at 4 Ohms. High Level input with Sensing Power On Direct connection (High Level Input) can be made with the speaker output of your car audio unit if it is not equipped with RCA line output. HiLevel Sensing power On feature allows the unit to be activated without need for remote connection. 50-300 Hz Variable Low-pass filter, 12 dB/oct Built in variable 12 dB/Oct LPF (Low Pass Filter) from 50-300Hz enables users to concentrate the power on lower frequencies. 6-70 Hz Variable subsonic filter, 12 dB/oct Built in variable 12 dB/Oct Subsonic filter from 6-70Hz enables users to create a band pass filter and block extremely low frequencies to improve the subwoofer systems efficiency. 0-10 dB Variable 40Hz Low boost Variable 0-10 dB 40Hz bass boost provides additional bass response at lower frequencies. 2/1 channel GTR amp Inputs and Outputs RCA Audio Input(s): Pin Jacks: 0.3 - 6V Audio In: RCA Pin Jacks, High Level Input Connector Audio Out: Speaker terminals with screws Dimensions Weight: 7 lbs. 15 oz. Measurements: 16 3/4 x 2 1/4 x 11 1/8" (424 x 55 x 280 mm) Supplied Accessories Mounting Screws (4) High Level Input Cord (1) Protection cap (1) Color: Gray and Silver UPC Code: 027242773066 1. CEA-2006 Compliant - Standardized "Voluntary"Testing & Measurement Methods for Mobile Audio Amplifiers. This standard advocates a uniform method for determining an amplifier's RMS power and signalto-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz. © 2010 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without written permission is prohibited. Sony, Quick-BrowZer, Walkman, Xplōd, ZAPPIN, and the Sony and Xplōd logos are trademarks of Sony. iPod is a trademark of Apple Inc. All other trademarks are trademarks of their respective owners. Features and specifications are subject to change without notice. Non-metric weights and measures are approximate and may vary. Specifications Audio Frequency Response: 10 - 50 kHz (+0/-3 dB) Input Level: 0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input) Impedance: 2-8 Ohms Stereo or 4-8 Ohms Mono Operation: 2/1 channel configuration Tone Control(s): Low Pass Filter: 50-300Hz, 12dB/Oct Subsonic filter: 6-70Hz, 12dB/Oct Harmonic Distortion: 0.05% (at 1kHz) Low Boost: 0-10dB Variable (at 40Hz) Signal-to-Noise Ratio (dB): 93 dBA Power Output Power: Maximum Output: 440 Watts x2 or 1400 Watts x1 (at 4 Ohms) Current Drain: At rated output: 50A (at 4 Ohms) Remote Input: 1 mA Rated Output: (20Hz-20kHz, 1% THD+N, 14.4V)1 220 Watts x 2 RMS (4 Ohms) 270 Watts x 2 RMS (2 Ohms) 540 Watts x 1 RMS Mono (4 Ohms) Power Requirements: 12V DC Car Battery (Negative Ground) Internal Power Supply: OTL Output Transformerless Circuit Pulse Power Supply Input Voltage: 10.5-16V Power Supply Voltage Please visit the Dealer Network for current information at www.sony.com/dn Sony Electronics Inc. •16530 Via Esprillo •San Diego, CA 92127 •1.800.222.7669 •www.sony.com Last Updated: 01/26/2010