Sony XR-C2300X Primary User Manual - Page 17

Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connections and operating procedures. General Problem Cause/Solution No sound. • Set the fader control to the center position for two-speaker systems. • Rotate the dial clockwise to adjust the volume. The contents of the memory have been erased. • The power cord or battery has been disconnected. • The reset button was pressed. t Store again into the memory. Indications do not appear in the Removethefrontpanelandcleantheconnectors.See display. "Cleaning the connectors" (page 15) for details. Tape playback Problem The sound is distorted. Cause/Solution The tape head is contaminated. t Cleantheheadwithacommerciallyavailabledry-type cleaning cassette. Radio reception Problem Preset tuning is not possible. Automatic tuning is not possible. The stations cannot be received. The sound is hampered by noises. The "ST" indication flashes. CD/MD playback Problem The sound skips. Cause/Solution • Memorize the correct frequency. • The broadcast signal is too weak. The broadcast signal is too weak. t Use manual tuning. Connect an power antenna control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's antenna booster. (When your car has built-in FM/AM antenna in the rear/side glass only.) • Tuneinthefrequencyaccurately. • Thebroadcastsignalistooweak. t Set to MONO mode (page 10). Cause/Solution A dirty or defective disc. 17