Stihl 056 Instruction Manual - Page 22
T1HL
View all Stihl 056 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Starting-throttle position Top: Starting Center: Chain brake disengaged Boltom: Stop switch in "STOP" position 5. To start the engine, hold saw firmly on the ground with your left hand around the handlebar (7) and put the toe of your right foot into the rear handle (8) and press down. 6. Pull out starter grip slowly with your right hand until you feel a definite resistance and then give it a brisk, strong pull. The starter rope should not be pulled out more than 80 cm (30 in.) as there is otherwise a risk of it breaking. Do not allow starter rope to snap back. Hold it vertically 130 that it can rewind correctly. 7. Once the engine is running, release the starting throttle lock (6) immediately by briefly squeezing the trigger so that the engine can settle down to idle speed. 8. On Quickstop models the chain brake has to be disengaged before you can start cutting - pull hand guard (1) back toward the handlebar (7). 9. The engine is stopped by flicking the stop switch (2) 20 to the "STOP" position. _ _ _7 5T1HL