Stihl FS 260 C Instruction Manual - Page 16

002BA354 KN 681BA209 KN 002BA396 KN English Using the Mowing Heads Do not use with mowing line longer than the intended length. With a properly mounted deflector, the built-in linelimiting blade will automatically adjust the line to its proper length. Using the unit with an overly long nylon cutting line increases the load on the engine and reduces its operating speed. This causes the clutch to slip continuously and results in overheating and damage to important components (e.g. clutch, polymer housing components). Such damage could, among other things, cause the cutting attachment to rotate at idle. Mowing heads are to be used only on clearing saws equipped with a linelimiting blade in the deflector in order to keep the line at the proper length (see "Main Parts" chapter in your instruction manual). If the lawn edges are planted with trees or bordered by a fence etc., it is best to use a nylon line head. It achieves a "softer" cut with less risk of damaging tree bark etc. than polymer blades. However, the polymer-bladed STIHL PolyCut produces a better cut if there are no plants along the edge of the lawn. Sharpening is not necessary, and worn polymer blades are easily replaced. WARNING To reduce the risk of serious injury, never use wire or metal-reinforced line or other material in place of the nylon cutting lines. Pieces of wire could break off and be thrown at high speed toward the operator or bystanders. STIHL SuperCut mowing head Fresh line is advanced automatically. Frayed line is replaced by a simple adjustment (see instruction sheet supplied with mowing head). STIHL AutoCut mowing head Nylon cutting line advances automatically when tapped against the ground (TapAction). STIHL TrimCut mowing head Frayed line is replaced by a simple adjustment (see instruction sheet supplied with mowing head). STIHL DuroCut mowing head Uses only nylon lines. Observe wear indicators. NOTICE There are four wear limit indicators shaped like exclamation marks in the base of the DuroCut. If one of these built-in indicators becomes visible, do not continue using the DuroCut since it might otherwise be damaged. Replace the worn base plate with a new base plate. It is important to follow the maintenance instructions supplied with the head. STIHL PolyCut mowing head Uses either nylon lines or nonrigid, pivoting polymer blades. Observe wear indicators. WARNING Three rectangular wear limit marks are applied to the base (periphery) of the PolyCut. To reduce the risk of serious injury from breakage of the head or blades, the PolyCut must not be used when it has worn as far as one of these marks. It is important to follow the maintenance instructions supplied with the head. WARNING If the wear limit marks are ignored, there is a risk of the cutting attachment shattering and flying parts injuring the operator or bystanders. To reduce the risk of accidents from shattered blades, avoid contact with stones, metal and similar solid objects. Check PolyCut 14 FS 360 C