Stihl GS 461 Rock Boss174 Product Instruction Manual - Page 10

English starting grip slowly with your right hand until you feel a definite resistance and then give it a brisk, strong pull. WARNING Be sure that the guide bar and chain are clear of you and all other obstructions and objects, including the ground. When the engine is started, the engine speed with the starting throttle lock engaged will be fast enough for the clutch to engage the sprocket and turn the chain. Never attempt to start the concrete cutter when the guide bar is in a cut or kerf. As soon as the engine is running, immediately blip the throttle trigger, which will disengage the starting throttle lock and allow the engine to settle down to idle. WARNING When you pull the starter grip, do not wrap the starter rope around your hand. Do not let the grip snap back, but guide the starter rope to rewind it properly. Failure to follow this procedure may result in injury to your hand or fingers and may damage the starter mechanism. Important Adjustments WARNING To reduce the risk of personal injury from loss of control and/or contact with the running cutting tool, do not use your unit with incorrect idle adjustment. At correct idle speed, the cutting tool should not move. For directions on how to adjust idle speed, see the appropriate section of your instruction manual. If you cannot set the correct idle speed, have your STIHL dealer check your power tool and make proper adjustments and repairs. During Operation Holding and Controlling the Power Tool Always hold the unit firmly with both hands on the handles while you are working. Wrap your fingers and thumbs around the handles. Your left hand should grip the front handlebar. Your right hand should grip the rear handle. This also applies to left-handers. With your hands in this position, you can best oppose and absorb the push and pull of your concrete cutter without losing control (see section on reactive forces). WARNING Your STIHL concrete cutter is designed for hand-held use. Cutting with your concrete cutter resting on the ground or other surface can cause excessive wear to the bracket designed to protect the bottom of the tank housing. Loss of fuel 2411BA046 KN and personal injury from fire may result. Replace damaged or badly worn brackets immediately. WARNING To reduce the risk of serious or fatal injury to the operator or bystanders from loss of control, never use the concrete cutter with one hand. WARNING To reduce the risk of cut injuries, keep hands and feet away from the cutting tool. Never touch a moving cutting tool with your hand or any other part of your body. WARNING Clear the area where you are working. Avoid stumbling on obstacles and watch out for holes or ditches. Be extremely cautious when working on slopes or uneven ground. Take extreme care in wet and freezing weather (rain, snow, ice.) Keep in mind that water from the water attachment may affect footing. WARNING To reduce the risk of injury from loss of control, never work on a ladder or any other insecure support. Never hold the machine above shoulder height. Do not overreach. 8 GS 461