Stihl KM 130 Instruction Manual - Page 21
Engine Management, Adjusting the Carburetor
View all Stihl KM 130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Engine Management Exhaust emissions are controlled by the design of the fundamental engine parameters and components (e.g. carburation, ignition, timing and valve or port timing) without the addition of any major hardware. Adjusting the Carburetor The carburetor comes from the factory with a standard setting. This setting provides an optimum fuel-air mixture under most operating conditions. These power tools are equipped with different carburetors: Version A HL LA - High speed screw and low speed screw with special head - without slotted head. On these machine versions it is no longer necessary to adjust the carburetor. These machines have been set at the factory to provide an optimum fuel-air mixture in all locations and operating conditions. 249BA066 KN 249BA066 KN Adjusting Idle Speed Engine stops while idling English HL LA N Warm up the engine for about 3 minutes. N Turn the idle speed screw (LA) slowly clockwise until the engine runs smoothly - the cutting attachment must not move. Cutting attachment runs when engine is idling N Turn the idle speed screw (LA) counterclockwise until the cutting attachment stops running and then turn the screw about another 1/2 to 3/4 turn in the same direction. If the working tool or cutting attachment continues to run when the engine is idling, have your machine checked and repaired by your servicing dealer. KM 110 R, KM 130 R 19