Stihl MS 260 Instruction Manual - Page 12
Warning, Operating instructions - chain size
View all Stihl MS 260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English / USA !Warning! Inhalation of certain dusts, especially organic dusts such as mold or pollen, can cause susceptible persons to have an allergic or asthmatic reaction. Substantial or repeated inhalation of dust and other airborne contaminants, in particular those with a smaller particle size, may cause respiratory or other illnesses. This includes wood dust, especially from hardwoods, but also from some softwoods such as Western Red Cedar. Control dust at the source where possible. Use good work practices, such as always cutting with a properly sharpened chain (which produces wood chips rather than fine dust) and operating the unit so that the wind or operating process directs any dust raised by the power tool away from the operator. Follow the recommendations of EPA/OSHA/ NIOSH and occupational and trade associations with respect to dust ("particulate matter"). When the inhalation of dust cannot be substantially controlled, i.e., kept at or near the ambient (background) level, the operator and any bystanders should wear a respirator approved by NIOSH/ MSHA for the type of dust encountered. !Warning! Breathing asbestos dust is dangerous and can cause severe or fatal injury, respiratory illness or cancer. The use and disposal of asbestos-containing products have been strictly regulated by OSHA and the Environmental Protection Agency. If you have any reason to believe that you might be cutting asbestos, immediately contact your employer or a local OSHA representative. Operating instructions !Warning! Do not operate your power tool using the starting throttle lock, as you do not have control of the engine speed. In the event of an emergency, switch off the engine immediately - move the slide control / stop switch to 0 or STOP. !Warning! Always stop the engine before putting a chainsaw down. !Warning! The saw chain continues to move for a short period after the throttle trigger is released (flywheel effect). Accelerating the engine while the saw chain is blocked increases the load and will cause the clutch to slip continuously. This may occur if the throttle is depressed for more than a few seconds when the chain is pinched in the cut or the chain brake is engaged. It can result in overheating and damage to important components (e.g. clutch, polymer housing components) - which can then increase the risk of injury, e.g., from the saw chain moving while the engine is idling. ! Warning! Your chainsaw is equipped with a chain catcher. It is designed to reduce the risk of personal injury in the event of a thrown or broken chain. From time to time, the catcher may be damaged or removed. To reduce the risk of personal injury, do not operate a chainsaw with a damaged or missing chain catcher. MS 260 11