Stihl TS 400 Instruction Manual - Page 38
Spark arresting screen, in the muffler, Checking the Spark Plug
![]() |
View all Stihl TS 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Spark arresting screen* in the muffler English / USA Checking the Spark Plug Setting idling speed : It is usually necessary to change the setting of the idle speed adjusting screw (LA) after every correction to the low speed adjusting screw (L). Engine stops at idle speed : Set to standard setting : Turn the idle speed adjusting screw (LA) clockwise until the abrasive wheel starts to run, then back off the screw one quarter of a turn. Abrasive wheel runs on at idle speed : Set to standard setting : Turn the idle speed adjusting screw (LA) counterclockwise until the abrasive wheel stops running, then turn screw another quarter turn in the same direction. Erratic idling behavior, poor acceleration Idle setting is too lean (e.g. at cold ambient temp.): : Turn the low speed adjusting screw (L) counterclockwise - until engine runs and accelerates smoothly. 12 The spark arresting screen in the muffler must be checked if the engine performance deteriorates. : Remove the retaining clip (1) and spark arresting screen (2) with suitable pliers : Clean the soiled spark arresting screen. : The screen must be replaced if it is damaged or there is a severe build-up of carbon. : Refit the spark arresting screen and retaining clip 338BA026 000BA002 KN Wrong fuel mix (too much engine oil in the gasoline), a dirty air filter and unfavorable running conditions (mostly at part throttle etc.) affect the condition of the spark plug. These factors cause deposits to form on the insulator nose which may result in trouble in operation. * see "Guide to Using this Manual" TS 400 37
![](/manual_guide/products/stihl-ts-400-instruction-manual-677d009/38.png)