Sub-Zero 661 Built-In Use and Care Guide - Page 18

S U B - Z E R O B U I LT- I N U S E & C A R E I C E | WAT E R D I S P E N S I N G M O D E L S DISPENSER LIGHTS For Models 685 and 695, there are three lighting states than can be cycled by pressing the LIGHT key pad on the glasswell. All lights OFF All lights ON (blue key pad and white glasswell) Key pad lights ON only During water or ice dispensing, all lights will illuminate until dispensing is complete, then lights will return to their previous state. D I SPE N SE R WATE R G R I LLE For Models 685 and 695, a water grille at the base of the glasswell will catch and evaporate small spills. Because there is no drain in this area, do not pour water into the water grille. To clean the area, remove the water grille by pressing the front left corner of the grille and lifting it out. LOCK For Models 685 and 695, the lock feature is used to prevent unintended ice and water dispensing. When the dispenser is locked, all key pads on the glasswell are deactivated to allow cleaning or to prevent small children from using the dispenser. To activate the lock feature, hold down the LIGHT key pad on the glasswell until the key pad lights flash once and the red LOCK icon is illuminated (approximately five seconds). The lights will remain in the state they were in before the lock feature was activated. To deactivate the lock feature, hold down the LIGHT key pad until the key pad lights flash once and the red LOCK icon is no longer illuminated (approximately five seconds). The lights will remain in the state they were in before the lock feature was deactivated. ICE DISPENSING Models 685 and 695 have a feature that limits the maximum amount of ice that is dispensed each time the ICE key pad on the glasswell is pressed. To dispense ice, hold down the ICE key pad for approximately two seconds. The dispenser will meter out ice for about two seconds, collect the ice directly above the glass, then drop the ice into the glass. If less ice is desired, hold the ICE key pad down for less than two seconds. If more ice is desired, hold the ICE key pad down until the dispensing cycle repeats. IMPORTANT NOTE: Be sure that dispenser key pads are clean and dry when pressed to avoid problems with the dispenser operation. 18