Sub-Zero 700BFI Integrated Installation Guide - Page 3

Integrated Refrigeration 3 subzero.com/specs Sub-Zero Integrated Refrigeration The importance of the installation of the Sub-Zero integrated unit cannot be overemphasized. Installation should be done by a qualified installer. Before you begin the installation process, it is recommended that you read this entire installation guide. There are key details that you should take special care to observe during the installation. By reading these instructions carefully, you will make the installation process easier, problem-free and most importantly, safe. Any questions or problems regarding the installation should be directed to your authorized Sub-Zero dealer or Sub-Zero customer care at 800-222-7820. You may also check the contact & support section of our website, subzero.com. Important product information, including the model and serial number of your unit are listed on the product rating plate. For column models, the rating plate is located inside the top drawer near the drawer guide opposite the hinge. For tall and drawer models, the rating plate is located inside the cabinet, to the left of the upper drawer. Refer to the illustrations below. RATING PLATE RATING PLATE Before You Start Make sure the opening dimensions, door and drawer clearances, electrical service and plumbing are correct for the model you are about to install. Refer to specifications on the following pages. IMPORTANT NOTE: The inside edges of the rough opening, as well as the sides and a portion of the backside of the decorative panels will need to be finished, as they will be exposed when the doors are open. TOOLS AND MATERIALS REQUIRED • Appliance dolly able to support 500 lbs (227 kg) and adequate manpower to handle the weight of the unit. • Phillips and slotted screwdrivers. • Allen, standard and crescent wrenches. • Various sized pliers. • 5/16" hex bolt nut driver. • Cordless drill and assorted drill bits. • Level-2' (.6 m) and 4' (1.2 m) recommended. • 4' (1.2 m) of 1/4" copper, braided stainless steel or PEX tubing and saddle valve for water line (do not use self-piercing valves). • Tubing cutter. • Masonite, plywood, pressed fiberboard, cardboard or other suitable material to protect finished flooring. • Appropriate materials to cover and protect the home and furnishings during installation. Column models. Tall and drawer models.