Sub-Zero BI-42UFD Advanced Design - Extended Height Grille - Page 6

Extended Height Grille 6 Grille Hinging System HINGING SYSTEM-INSTALL CLEAT HINGING FOR DECORATIVE GRILLE PANEL 11/2" (38) 1/2" (13) LIP HINGING FOR DECORATIVE GRILLE PANEL 2" (51) CLEAT END VIEW GRILLE CLEARANCE REQUIRED FOR SERVICE CLEAT STANDARD GRILLE FRAME IN CLOSED POSITION SIDE VIEW STANDARD GRILLE FRAME IN FULLY RAISED POSITION Specify the customer-supplied hinging system consistent with cabinetry and with sufficient capacity for the weight of the decorative grille panel. IMPORTANT NOTE: In the event that refrigeration components must be removed for service, the standard grille frame will need to be removed first for sufficient access to the machine compartment. To avoid an unsupported load, the decorative panel will need to be removed from the cabinetry first. Field install a cleat to the back side of the decorative grille panel to hold the flip-up inner grille frame in position when it is raised. Follow dimensions in the inset illustration for the 10" (254) long cleat. For location of the cleat, also refer to the illustration on the following page. The cleat must include a lip as shown, to prevent unintentional separation of decorative grille panel and grill frame. For a dual installation, use two cleats.